EXP511,513/00c.1 eng 1/3/02 15:11 Page 24
FeaturesAccessories
ESP and powersavingIn-car connections (supplied or optionally available)English
With a conventional portable disc player Use only the AY 3545 or AY 3548 car voltage converter (4.5 V DC, positive
the music may stop while you are jogging, forpole to the centre pin) and the AY 3501 car adapter cassette.Any otherEnglish
example.The Electronic Skip Protectionproduct may damage the set.
1Put the set on a horizontal,vibration-free andprotects this set against loss of sound caused
stable surface. Make sure it is in a safe place,by light vibrations or shocks. Continuous
where the set is neither a danger nor anplayback is ensured. ESP does not protect
obstacle to the driver and the passengers.the set against damage caused by
dropping!
2Plug the voltage converter into the cigarette
lighter socket (only for a 12 V car battery,Press ESP repeatedly during playback to select
negative grounding), then connect theeither:
wired end with the 4.5V DC input socket on� ESP on:is shown and ESP is
the set.switched on.
� Longer battery playing time:
is shown. ESP and powersaving are switched on, resulting in 3If necessary,clean the cigarette lighter socket to obtain a good electrical
a longer battery lifetime and a shorter skip protection.contact.
� ESP off:disappears. ESP and powersaving are switched off
4Turn down the volume and connect the adapter cassette plug tofor CD Audio tracks to achieve the highest sound quality.
LINE OUT/p on the set.
Beep5Carefully insert the adapter cassette into the car radioOs cassette
A beep conŢrms that you have pressed acompartment.
button or that the batteries are empty.
6Make sure the cord does not hinder your driving.
Keep DBB/TREBLE pressed for 2seconds to
7Set VOL Eon the set to position8.Start playbackon the set and adjustswitch beep either on or off:
the sound with the car radio controls.�Beepis displayed:Beep is switched on.
�No beepis displayed:Beep is switched off.Always remove the voltage converter from the cigarette lighter socket
when the set is not in use.
Note:If your car radio has a LINE IN socket,it is better to connect the set to
this socket instead of using the adapter cassette.Connect LINEOUT/p of the
set with the LINE IN socket of your car radio with an appropriate cable.
2425 |
ACEC
