ENGLISH9
5 To continue vacuum cleaning, simply press the - button or the + button.The appliance will
start operating at the previously selected suction power setting again.
Parking the tube
1 By inserting the ridge on the nozzle into the parking slot, you can park the tube in a
convenient position (fig. 23).
Storage
1 You can put the appliance in upright position and attach the nozzle to the appliance by
inserting the ridge on the nozzle into the slot (fig. 24).
2 Always put the Tri-Active nozzle in the carpet setting when you store it and prevent the side
brushes from becoming bent.
Replacement
The dustbag
1 Replace the dustbag as soon as the dustbag-full indicator changes colour (fig. 25).
The dustbag is full when the colour of the indicator has changed when the nozzle is not placed
on the floor.
2 Switch the appliance off.
3 Open the cover by pulling it upwards (fig. 26).
Place your fingers at the front of the cover and press with your thumb on the ridge on top of the
cover.
4 Lift the dustbag holder out of the appliance (fig. 27).
Make sure you hold the dustbag upright when lifting it out of the appliance.
5 Remove the full dustbag from the holder by pulling the cardboard tag (fig. 28).
When you do this, the dustbag will be automatically sealed.
6 Slide the cardboard of the new dustbag into the two grooves of the dustbag holder as far as
possible. Re-insert the dustbag holder into the vacuum cleaner (fig. 29).
You cannot close the cover if no dustbag has been inserted.
The cotton dustbag (specific types only)
If provided, you can use the cotton dustbag instead of paper dustbags.The cotton dustbag can be
used and emptied repeatedly.
1 To empty the cotton dustbag:
- Hold the dustbag over a dustbin.
- Remove the clip by sliding it off the dustbag sideways.
- Undo the metal hooks.
- Close the dustbag by fastening the metal hooks and sliding the clip back onto the bottom edge
of the dustbag.
Cleaning and maintenance of filters
Motor Protection Filter
Every time you empty or replace the dustbag, clean the Permanent Motor Protection Filter.
1 Remove the dustbag holder with the dustbag (fig. 27). |
ACEC
