(2) or the small brush (3) directly to theInfrared remote control (specific types
handgrip or to the tube.(fig.11)only)
1 Place the batteries in the battery
Accessory holdercompartment.(fig.18)
1 The accessory holder can simply be snappedMake sure the - and + poles are pointing in the
onto the handgrip. (fig.12)right direction.
� There are two ways to store accessories in
� With the infrared remote control you can set
the accessory holder.the suction power to one of 5 different
� The crevice tool and small nozzle can besuction power settings.When you switch the
stored in the accessory holder by pushingappliance on, it will always start running at the
them into the holder.To detach them, pullhighest suction power setting.
them out of the holder.(fig.13)2 By pushing the - button, you will reduce the
Please note the way in which the small nozzlesuction power by one setting.(fig.19)
must be placed in the accessory holder.3 By pushing the + button, you will increase the
� Instead of the small nozzle, the small brushsuction power by one setting.
can be stored in the accessory holder by4 Push the standby button to temporarily
pushing it into the holder.(fig.14)switch the vacuum cleaner off, for instance
Animal brush (specific types only)when you have to move some furniture.
5 To continue vacuum cleaning, simply press the
While combing your dog or cat with the Animal- button or the + button.The appliance will
Brush, dirt, loose hairs and knots will be removed.
Regular combing will keep the fur healthy.start operating at the previously selected
suction power setting again.
1 Connect the animal brush to the handgrip
('click').(fig.15)Parking the tube
2 Place the vacuum cleaner as far away from1 By inserting the ridge on the nozzle in the
the dog or cat as possible. Set the suctionparking slot, you can park the tube in a
power to the lowest setting.convenient position.(fig.20)
3 For optimal results, move the brush throughStoring the vacuum cleaner
the fur of the cat or dog in one direction.
1 You can put the appliance in upright position
4 You can remove hairs from the Animal Brushand attach the nozzle to the appliance by
by detaching it from the appliance andinserting the ridge on the nozzle in the
vacuum cleaning it.(fig.16)
slot.(fig.21)
Vacuum cleaning
Replacing the dustbag
Adjusting suction power
1 Replace the dustbag as soon as the dustbag-
� You can adjust the suction power whilefull indicator changes colour. (fig.22)
vacuum cleaning.
The dustbag is full when the colour of the
1 Use the slide control on top of theindicator has changed even when the nozzle is
appliance.(fig.17)not placed on the floor.
2 Use maximum suction power for vacuum2 Switch the appliance off.
cleaning very dirty carpets and hard floors.3 Open the cover by pulling it upwards.(fig.23)
3 Use minimum power for vacuum cleaningPlace your fingers at the inlet of the cover and
curtains, table carpets, etc.press with your thumb on the ridge on top of
the cover.
7 |
ACEC
