8English
- Crevice nozzle and small nozzle (Fig. 12).
Please note how the small nozzle must be placed in the accessory holder.
- Crevice nozzle and brush nozzle (Fig. 13).
using the appliance
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
Press the on/off button on top of the appliance with your foot to switch on the
appliance (Fig.14).
infrared remote control (specic types only)
1 Place the batteries in the battery compar15). tment (Fig.
Make sure the - and + poles point in the right direction.
- With the infrared remote control, you can set the suction power to one of 5 different suction
power settings. When you switch on the appliance, it always starts running at the highest suction
power setting.
- To reduce the suction power by one setting, press the - button 16). (Fig.
- To increase the suction power by one setting, press the 17). + button (Fig.
Press the standby button to switch off the vacuum f orcleaner instance temporaril when y,
you have to move some furnitur (Fig. 18)e.
To continue vacuum cleaning, press the standby button The aagain.ppliance then starts
operating at the previously selected suction power setting again.
adjusting suction power
- During vacuum cleaning, you can adjust the suction power with the knob on top of the
appliance. (Fig. 19)
- If your appliance has a remote control, you can adjust the suction power with the + and -
buttons. See section Infrared remote control (specic types only).
- Use maximum suction power to vacuum clean very dirty carpets and hard oors.
- Use minimum suction power to vacuum clean curtains, table carpets, etc.
Parking the tube
- If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to park
the tube in a convenient position (Fig. 20).
replacing/emptying the dustbag
Always unplug the appliance before you replace or empty the dustbag.
Paper dustbag
- Replace the dustbag as soon as the dustbag-full indicator has changed colour permanently, i.e.
even when the nozzle is not placed on the oor 21). (Fig.
1 Pull the cover upwards to open22). it (Fig.
Lift the dustbag holder out of the 23). appliance (Fig.
Make sure you hold the dustbag upright when you lift it out of the appliance.
Pull at the cardboard tag to remove the full dustbag 24). from the holder (Fig.
, The dustbag is sealed automatically.
4 Slide the cardboard front of the new dustbag intothe thedustbag two grholderooves asof
far as possible (Fig. 25). |
ACEC
