6English
general description (Fig. 1)
1 Cord rewind button
2 Suction power knob (in case of remote control: infrared receiver)
3 On/off button
4 Dustbag-full indicator
5 Hose connection opening
6 Hose with swivel connector
7 Dust cover release tab
8 Motor Protection Filter holder
9Remo vable strip (specic types only)
10 Reusable dustbag (specic types only)
11 Dustbag holder
12 Paper dustbag
13 Rear wheel
14 Small nozzle
15 Crevice nozzle
16 Brush nozzle
17 Button coupling
18 Hose with handgrip (specic types only: with remote control)
19 Accessory holder
20 Tri-Active nozzle
21 Rocker switch for carpet/hard oor settings
22 Parking/storage ridge
23 Side brush
24 Tri-Scopic tube
25 Hinging top handle
26 Filter grille (open)
27 Parking slot
28 Mains plug
29 Super/Ultra Clean Air HEPA Filter
30 Front handle
31 Swivel wheel
32 Storage slot
33 Type plate
important
Read this user manual carefully before you use the appliance and save it for future reference.
- Check if the voltage indicated on the appliance corresponds to the local mains voltage before
you connect the appliance.
- Do not use the appliance if the plug, the cord or the appliance itself is damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by
Philips or similarly qualied persons in order to avoid a hazard.
- Keep the appliance out of the reach of children.
- Never suck up water or any other liquid. Never suck up ammable substances and do not suck
up ashes until they are cold.
- Do not point the hose, the tube or any other accessory at the eyes or ears nor put it in your
mouth when it is connected to the vacuum cleaner and the vacuum cleaner is switched on.
- When you use the vacuum cleaner to vacuum ashes, ne sand, lime, cement dust and similar
substances, the pores of the dustbag become clogged. As a result, the dustbag-full indicator will
indicate that the dustbag is full. Replace the dustbag, even if it is not full yet (see chapter
Replacement). |
ACEC
