Preparation
Do not insert the power plug in a wall socket before
all connections are made.(Remote control:Remove the cover of the battery
compartment.
Insert the 2 batteries supplied (Type R6AA-1.5V).
min.
4 ft
The batteries supplied do not contain the heavy metals mercury
and cadmium.Nevertheless in many areas exhausted batteries
may not be disposed of with your household waste.Please check
&Place the receiver box wherever you want,but make sureon how to dispose of batteries according to local regulations.
that air can circulate freely through the ventilation slots. Do
not install the receiver box in a confined space such as a
book case or a similar unit.§Turn the receiver on:Press the power button Aat the
To prevent any unsafe situations, no naked flame sources,right side of the monitor and the one on the front of the
such as lighted candles, should be placed on or in thereceiver box.
vicinity.Avoid heat, direct sunlight and exposure to rain orA green indicator and the screen light up.
water.
The equipment must not be exposed to dripping orNote:After turning on your TV receiver box with the power switch,
splashing and no objects filled with liquids, such as vases,wait about 5 seconds to turn on your PDP Flat TV monitor.
should be placed on it.
éConnect the antenna cable 1and the VGA cable with
trailing audio cinch connectors 2 as shown in the inside
frontcover of this handbook.
Make sure all screws of the cable 2 are tightened well.
TV receiver box with speakerless monitor
In case you connect your TV receiver box with a speakerless
B
monitor,all references made in this instruction book to sound
reproduction,volume control,and audio connections,are not
applicable (except for a headphone connection).
The buttons on the remote control referring to sound have no
function either.
The green indicator blinks every time you press a button on the
remote control.
ŤTo connect your computer,see the separate supplied
When you turn on your set for the first time,the menu
instruction manual with your monitor.
LANGUAGEautomatically appears on the screen.Alternately
To connect other accessory devices, see p. 16.
the explanation appears in different languages.
In order to obtain the best result, please use only the
supplied antenna cables between the receiver box and
videorecorder, and between videorecorder and antenna
connector.
ŹInsert the power cord supplied 3into the MAINS at the
back of the monitor and the power cord 4 at the back of
the receiver. Put both in the wall sockets with an AC power
supply of 110 V. Consult your local dealer if your AC power
supply is different.
Please, only use the power cord 3 supplied with the
monitor, for the monitor, and use the power cord supplied
with the receiver, only for the receiver.
4 |
ACEC
