General Information
IMPORTANT!
Safety Information
PLEASE NOTE THAT THE VOLTAGE
Before operating the system, check that the
SELECTOR LOCATED AT THE REAR OF
operating voltage indicated on the typeplate (or
THIS SYSTEM IS PRESET AT 220V FROMEnglish
THE FACTORY. FOR COUNTRIES THATthe voltage indication beside the voltage
selector) of your system is identical with the
OPERATE AT 110V-127V, PLEASE ADJUST
voltage of your local power supply. If not, please
TO 110V-127V BEFORE YOU SWITCH ON
consult your dealer.
THE SYSTEM.
Place the system on a flat, hard and stable
surface.
Environmental Information
Place the system in a location with adequate
All unnecessary packaging has been omitted. We
ventilation to prevent internal heat build-up in
have tried to make the packaging easy to
your system. Allow at least 10 cm (4 inches)
separate into three materials: cardboard (box),
clearance from the rear and the top of the unit
polystyrene foam (buffer) and polyethylene (bags,
and 5 cm (2 inches) from each side.
protective foam sheet).
Do not expose the system, batteries or discs to
Your system consists of materials which can beexcessive moisture, rain, sand or heat sources
recycled and reused if disassembled by acaused by heating equipment or direct sunlight.
specialised company. Please observe the local If the system is brought directly from a cold to a
regulations regarding the disposal of packagingwarm location, or is placed in a very damp room,
materials, exhausted batteries and oldmoisture may condense on the lens of the disc
equipment.unit inside the system. Should this occur, the CD
player would not operate normally. Leave the
power on for about one hour with no disc in the
Acknowledgement
system until normal playback is possible.
Energy Star The mechanical parts of the set contain self-
R
As an ENERGY STARlubricating bearings and must not be oiled or
Partner; Philips haslubricated.
determined that this product When the system is switched to Standby
R
meets the ENERGY STARmode, it is still consuming some power.
guidelines for energy efficiency.To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
Supplied accessories
� Remote control
� Batteries (two AA size) for remote control
� AM loop antenna
� FM wire antenna
� AC power cord
7
pg 001-028/C555/21-Eng712/11/01, 5:22 PM3139 115 21161 |
ACEC
