TUNER
Storing Preset Radio StationsManual programmingTuning to Preset Radio Stations
1 Press TUNER.
You can store up to 40 radio stations in the memory.Y Press PRESET 4 or 3 to select the desired presetEnglish2 Press TUNER (BAND) to select the desired
When a preset radio station is selected, the presetnumber.
waveband: FM, MW or LW.
number appears next to the frequency on the display.3 Press PROGRAM for less than one second.a The preset number, frequency and waveband
a PROGRAM flag, the frequency and preset stationappear on the display.
Automatic programming
1 Press TUNER.number start flashing.
2 Press TUNER (BAND) again to select the desireda The next available preset number will be displayed
waveband : FM, MW or LW.for selection.
3 Press PROGRAM for more than one second.4 Press TUNING ? or ? to tune to the desired
a PROGRAM flag starts flashing and "AUTO" will befrequency.
Y When all 40 presets are stored, no preset number is
displayed.
a Every available radio station will be storedshown.
automatically. The frequency and preset numbera The message OPROGRAM FULL� will be
will be displayed briefly.displayed.
a The system will stop searching when all theY If you wish to store the radio station to another preset
available radio stations are stored or when thenumber, press PRESET 4 or 3 to select the desired
preset number.
memory for 40 preset radio stations is used.
a The system will remain tuned to the last stored5 Press PROGRAM again.
preset radio station.a PROGRAM flag will stop flashing, and the radio
station will be stored.
Y Repeat the above procedure to store other preset
stations for the other waveband. Remember to selectY Repeat the above procedure to store other preset radio
the next available preset number before proceeding. Ifstations.
not, some of the preset radio stations may be erased.
Notes:
Notes:� You can cancel the manual programming by pressing
� You can cancel the automatic programming bySTOP ?.
pressing PROGRAM or STOP ?.� During programming , If no button is pressed within 20
� If you want to reserve a section of preset numbers, forseconds, the system will exit program mode
example preset numbers 1 to 9, select preset 10automatically.
before starting automatic programming: now only the
preset numbers 10 to 40 will be programmed.
19
3139 116 17601
pg 001-27/FW775-765P/22-Eng199/1/99, 9:37 AM |
ACEC
