TROUBLESHOOTING
EnglishWARNING! Under no circumstancesODISC NOT FINALIZED� isGeneralRemote control has no effect on the
you should try to repair the set yourselfdisplayed.system.
as this will invalidate the guarantee.Y The CD-RW or CD-R disc is not properlySystem does not react when anyY Wrong source is selected.
Do not open the set as there is a risk ofrecorded for the use on a standard CDbutton is pressed.aSelect the source (CD, TUNER, etc.)
electric shock.player.Y Electrostatic discharge.before pressing the function button,
aRead the instruction booklet of your CD-aPress STANDBY-ON to switch the(PLAY, PREV/NEXT, etc.).
Y If a fault occurs, check the points listedsystem off. Remove the AC power plug
below before taking the system forReWriteable or CD-Recorder on how toY The distance to the system is too large.
finalize a recording.from the wall outlet, then reconnect theaReduce the distance.
repair.
Y Should any problems persist after youY The CD is badly scratched or dirty.power plug and switch on the systemY Batteries are inserted incorrectly.
aReplace or clean CD.again.aInsert the batteries with their polarities
have made these checks, consult your
nearest dealer or service center.No or poor sound.(+/� signs) as indicated..
Y Batteries are exhausted.
Radio ReceptionY Volume is not turned up.
aAdjust the volume.aReplace the batteries.
CD Player OperationPoor radio reception.Y The headphones are connected.Timer is not working.
Y The signal is too weak.
ONO DISC� is displayed.aDisconnect the headphones.Y Clock is not set.
Y The disc is inserted upside down.aAdjust the antenna.Y Speakers are not connected or areaSet the clock.
aConnect an external antenna for better
aPlace CD with printed side up.connected wrongly.Y Timer is not switched on.
Y Moisture condensation at the lens.reception.aCheck that the speakers are connectedaPress CLOCK/TIMER to switch on the
Y The TV or VCR is too close to the stereo
aWait until lens has adjusted to normalcorrectly.timer.
room temperature.system.aMake sure the stripped speaker wire isY Dubbing/recording is in progress.
aSeparate the stereo system from the TV
Y There is no disc in the CD tray.clamped.aStop dubbing/recording.
aInsert a CD.or VCR.
Reversed left and right sound.
Y The CD is dirty, badly scratched orY Speakers are connected wrongly.Clock setting is erased.
warped.Tape Deck OperationY There was a power failure.
aCheck the speaker connections and
aClean or replace the CD.Recording or playback cannot occurlocation.aReset the clock.
Y The CD lens is dirty or dusty
aSee section under Maintenance.or there is a decrease in audio level.Lack of bass sound or apparentlySystem displays features
Y Dirty tape heads, capstans or pressureautomatically; buttons flash
imprecise physical location of musical
rollers.continuously.
aSee section on tape deck maintenance.instruments.Y Demonstration mode is switched on.
Y Speakers are connected wrongly.
Y Magnetic build-up in the record/aPress and hold ? (on the system) for 5
playback head.aCheck the speaker connection forseconds to switch off the
proper phasing, red/black wires to red/
aUse demagnetizing tape.black terminals.demonstration.
32 |
ACEC
