FW880P-880W/22-Eng 6/15/00 4:06 PM Page 8
DOLBY PRO LOGIC
Englishrear speakers (not supplied for model FW880P) fromthe speakers affect the picture of the television, you
Dolby Pro Logic
the SURROUND OUT terminals.should increase the separation distance.
This state of the art Dolby Pro Logic mini system enables
you to experience and enjoy a Home Cinema soundCenter Speaker
ambience. The Pro Logic system allows more accurateFor best directional effect, try to have the center speaker
definition of the individual sound sources. It producesCENTERat the same height as the left and right speakers and as
greater sound separation between channels andclose as possible to the screen. Place it directly above or
provides pinpoint sound localisation. Pro Logic providesREARbeneath the television set.SURROUNDFRONT
four outputs which are called Left, Center, Right andRear (surround) Speakers
REARFRONT
Surround (Rear). Front signals are produced from the pairLEFTThe surround speaker should be placed at normal
LEFT
of Left and Right speakers and a Center speaker. Thelistening ear level. It can also be mounted on the wall at
surround signal is reproduced by two speakers placed atREARthe back of the room. Most important , sometimes you
FRONT
the rear of the listening area. Although the surroundRIGHTRIGHTneed to experiment creatively when placing the surround
signal is mono, a pair of speakers is necessary tospeakers in order to obtain the most ideal sound
produce the correct diffused sound field.projection.
This Pro Logic decoder enables you to decode thePositioning the Speakers
following mode : Dolby Surround, Center Phantom,To get the best surround sound effect, place theTest Tone
Dolby 3 Stereoor normal Stereo.
speakers as follow. This feature enables you to adjust the Front Left, Front
Right, Center and Surround sound level of the respective
CENTER
Setting up the Dolby Pro Logic systemSPEAKERMINI HIFIspeakers in Dolby Pro Logic mode.
SYSTEM
FRONTFRONT
You need to do a proper set up in order for you to enjoyLEFTRIGHTYou must sit at the ideal sitting position and use the
the Home Cinema sound to the fullest. First you need toTVremote control to perform this operation.
do a complete speakersO connection.
1 Press CD, TUNER, TAPE or AUXYDVD to switch on
5-Speakers Connectionthe system.
YFront speakers : Connect the black wires to the2 Press TEST TONE.
SURROUNDSURROUND
black FRONT terminals and the red wires to the redLEFTRIGHTa A test signal is generated and it will move through
FRONT terminals.
the Left, Center, Right and Surround speakers
YCenter speaker : Connect the black or non-marked
respectively.
wires to the black CENTER terminal and the blue or
Front Left and Right Speakersa OTESTTONE� followed by OADAPT
marked wires to the blue CENTER terminal.
For best listening effect, it is recommended to have the
YRear (surround) speakers : Connect the black orBALANCE, CENTER AND REAR
Left and Right speakers to form an angle of
non-marked wires to the black REAR terminals andLEVEL� will be displayed.
approximately 45 degrees to the listener. The speakers
the white or marked wires to the grey REARa The test signal will last for about 90 seconds.
are magnetic shielded. Should the magnetic field from
terminals. You may also connect a pair of wireless
8 |
ACEC
