General Information
Refer to the type plate on the rear or
Care and safety information
bottom of the system for identification
and supply ratings.(page 3 - P2)
Avoid high temperatures, moisture,English
Supplied accessories (page 3 - P1)water and dust
� Do not expose the system, batteries or discs
� Remote control and two AA batteries.
to humidity, rain, sand or excessive heat (caused
� AM loop antennaby heating equipment or direct sunlight). Always
� FM wire antenna
keep the disc tray closed to avoid getting dust on
� Video cinch cable (yellow)the lens.
� AC power cord
Avoid condensation problem
� The lens may cloud over when the system is
Environmental informationsuddenly moved from cold to warm
surroundings, making it impossible to play a disc.
All unnecessary packaging has been omitted. WeLeave the system in the warm environment until
have tried to make the packaging easy tothe moisture evaporates.
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,Do not block the vents
� In a cabinet, allows about 10cm (4 inches) of
protective foam sheet).
free space all around the system for adequate
Your system consists of materials which can beventilation.
recycled and reused if disassembled by aCare of disc
specialized company. Please observe the local
� To clean a CD, wipe it in a straight line from
regulations regarding the disposal of packagingthe center towards the edge using a soft, lint-free
materials, exhausted batteries and old
cloth. Do not use cleaning agents, as they may
equipment.damage the disc!
� Write only on the printed side of a CDR(W)
and only with a soft felt-tipped pen.
� Handle the disc by its edge, do not touch the
surface.
Care of the cabinet
� Use a soft cloth slightly moistened with a mild
detergent solution. Do not use a solution
containing alcohol, spirits, ammonia or abrasives.
Finding a suitable location
� Place the system on a flat, hard, stable surface.
Built-in safety circuit
� Under extreme conditions, this system may
switch to standby mode automatically. If this
happens, let the system cool down before
reusing it.
Power saving
� This system is designed to use less than 1W
of electricity when switches to Eco Power
standby. Disconnect the AC power cord from
the power outlet when not in use.
9 |
ACEC
