PHILIPS FW-C58/30 Instruction Manual

CLOCKTIMER
English5 Press CLOCK/TIMER again to store the
Timer Setting
setting.
MINI HIFI SYSTEMPROGRAMREPEATTIMER SHUFFLERECSTEREOBACKY The system can switch on to CD,
NEWST.A.AMMWFMLWFRONTHSD" The clock starts.
60Hz 250Hz500Hz1KHz2KHz4KHz8KHzTUNER, or TAPE 2 mode automatically
STANDBY
ONY To exit without storing the setting, pressat a preset time. It can serve as an
� on the system.alarm to wake you up.
CLOCK/
TIMERCD1 Y 2 Y 3BANDTAPE 1 Y 2 CDR/VIDEO
Y Before setting the timer, make sure the
Notes:
CDTUNERTAPEAUXclock is set correctly.
PROG
PRESET
A. REV� During clock setting, if no button is
SEARCH Y TUNINGSTOPYCLEAR PLAY PAUSEPREVSIDE NEXT
Y The timer will always be switched on
(HSD)DUBpressed within 90 seconds, the system
once it is set.
MICwill exit clock setting mode
RECSOUND NAVIGATIONLEVELY The volume of the timer will
MIC INCREDIBLEDYNAMIC BASSBOOSTautomatically.
SURROUNDincrease from the minimum level
� When a power interruption occurs, the
DIGITALclock setting is erased.until the volume level before the set
SOUND CONTROL
is switched to standby mode.
1 Press and hold CLOCK/TIMER for more
View ClockClock Settingthan 2 seconds to select timer mode.
You can view the clock (if it is set) if theThe clock can be set in either 12- or 24-" "AM 12:00" or "00:00" or the
system is in Standby mode or when anyhour mode, e.g. "AM 12:00" orlast timer setting starts flashing
sound source is selected (CD, TUNER, etc.)."00:00". Before setting the clock, youdepending on whether you have
The clock will be displayed for about sevenmust be in the View Clock mode.selected 12- or 24-hour mode.
seconds." The TIMER starts flashing.
1 Press CLOCK/TIMER to select clock
" The selected source is lit while other
Y Press CLOCK/TIMER briefly.mode.
available sources are flashing.
" "PM 10:38 or 22:38" (the2 Press PROG (on the system only) to
2 Press CD, TUNER or TAPE to select the
current time) will be displayedselect 12- and 24- hour mode.
desired source.
depending on whether you have" If 12-hour mode is selected,
Y Before selecting CD or TAPE, make sure
selected 12- or 24-hour mode."AM 12:00" starts flashing.
a CD or tape is loaded in the CD tray or
" "--:::::--" will be displayed if the" If 24-hour mode is selected,
tape deck 2.
clock is not set."00:00" starts flashing.
3 Press a or á on the system to set the
3 Set the hour with a or á on the
hour for the timer to start.
system.
4 Press í or ë on the system to set the
4 Set the minute with í or ë on the
minute for the timer to start.
system.
22
Untitled-5226/8/01, 10:26 AM3139 116 19751