Clock/Timer
English2Press CD, TUNER or TAPE to select theSleep Timer Setting
desired source.The sleep timer enables the system to switch to
Before setting the timer, make sure the music
source has been prepared.Standby mode automatically within a preset
CD Load the disc(s). To start from a specificamount of time.
track, make a programme (refer to CD1Press SLEEP on the remote control repeatedly
Operation - Programming the disc tracks).to select a preset amount of time.
TUNER tune to the desired radio station.� The selections are as follows (time in
TAPE load the prerecorded tape into tapeminutes):
deck 2.15 " 30 " 45 " 60 " OFF " 15
3Pressa or á on the system repeatedly to set� "SLEEP XX" or "OFF" will be displayed. "XX"
the hour for the timer to start.is the time in minutes.
4Pressà or ë on the system repeatedly to set2When you reach the desired length of time, stop
the minute for the timer to start.pressing the SLEEP button.
5Press CLOCKYTIMER to store the start time.�SLEEP will appear on the display, except for
� "TIMER ON" will be displayed and followed"OFF" mode.
by the set timer "XX:XX" and then the selected� The Sleep Timer is now set. Before the
source.system switches to standby mode, a countdown
�TIMER will remain on the display.of 10 seconds will be displayed.
At the preset time, the selected source will play."SLEEP 10" " "SLEEP 9".... " "SLEEP 1"
" "SLEEP"
To exit without storing the setting
Press �on the system.While SLEEP mode is activated
To check the remaining length of time
Notes: Press SLEEP once.
� If CD is the selected source and it is not
available when the preset time is reached, TunerTo change the preset sleep timer
will be selected automatically. Press SLEEP twice.
� During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting� The display will show the remaining time
followed by the sequence of sleep timer options.
mode automatically.
To deactivate the Sleep Timer
To deactivate the TIMER Press SLEEP repeatedly until "OFF" is displayed,
Press TIMER ON/OFF on the remote control.or press the STANDBY ON button.
� The display will show "CANCEL" and TIMER
will disappear from the display.
To activate the TIMER
Press TIMER ON/OFF on the remote control.
� The last set timer information will be shown
for a few seconds and TIMER will appear on
the display.
24
pg 001-027/C720-C780/21-Eng246/8/01, 8:45 AM3139 115 20592 |
ACEC
