Preparations
CSpeakers ConnectionConnecting other equipment to your
system
Front Speakers
Connect the audio left and right OUT terminals
Connect the speaker wires to the SPEAKERS
of a TV, VCR, Laser Disc player, DVD player orEnglish
(FRONT) terminals, right speaker to "R" and left
CD Recorder to the AUX/CDR IN terminals.
speaker to "L", coloured (marked) wire to "+"
and black (unmarked) wire to "-".Notes:
� Do not connect equipment to both the LINE
OUT and AUX/CDR IN terminals at the same time.
Otherwise, noise will be generated and malfunction
12might occur.
� If you are connecting equipment with a mono
Fully insert the stripped portion of the speakeroutput (a single audio out terminal), connect it to
wire into the terminal as shown.the AUX/CDR IN left terminal. Alternatively, you
can use a Osingle to double� cinch cable (still be
Rear Surround Speakers (for model
mono sound).
FW-C720 only)
Connect the speaker wires to the REAR
SURROUND terminals, right speaker to "R" andDigital Out Connection
left speaker to "L", coloured (marked) wire toConnect this digital output when recording on
"+" and black (unmarked) wire to "-".any audio equipment with digital input (CD
Recorder, Digital Audio Tape [DAT] deck, Digital
Notes:to Analogue Converter and Digital Signal
� For optimal sound performance, use theProcessor, for example). Use a coaxial cable to
supplied speakers.connect the DIGITAL OUT terminal to the
� Do not connect more than one speaker to anydigital input terminal of the equipment.
one pair of +/- speaker terminals.
� Do not connect speakers with an impedanceInserting batteries into the
lower than the speakers supplied. Please refer to
Remote Control
the SPECIFICATIONS section of this manual.
Insert two batteries (Type R06 or AA) into the
remote control with the correct polarity as
indicated| by the + and - symbols inside the
Optional Connectionsbattery compartment.
The optional equipment and connecting cords
are not supplied. Refer to the operating21
instructions of the connected equipment for
details.
Line Out Connection
Connect this output to any analogue audio
equipment for playback or recording (CD
recorder, tape recorder or amplifier for example).
CAUTION!
Use a cinch cable to connect the LINE OUT
� Remove batteries if they are exhausted
terminals to the analogue audio in terminals of
or will not be used for a long time.
the equipment.
� Do not use old and new or different
types of batteries in combination.
� Batteries contain chemical substances, so
they should be disposed off properly.
9
pg 001-027/C720-C780/21-Eng96/8/01, 8:44 AM3139 115 20592 |
ACEC
