ENGLISH17
� After you have switched off the tanning lamps or infrared lamps,
the fans will continue to work for three more minutes.
This is convenient, because it enables you to use the tanning lamps
again only 3 minutes after switching them off (the infrared lamps do
not require a cooling-down period before they can be switched on
again!)
BIf you have switched the tanning appliance off by removing the plug from
the wall socket,the fans won't provide cooling for three more minutes,of
course.
BIf you have switched the tanning appliance off by removing the plug from
the wall socket and another person wishes to use the appliance for a
tanning session right away,the newly set time won't blink on the display.
This means that the next person will have to keep track of the three-
minute cooling-down period himself.
BHB975 only:If you want to use the appliance for a tanning session
immediately after having used it for a relax session (l),you should also
let the appliance cool down for three minutes.As a result of the relax
session,the tanning lamps will have become hot and will need to cool
down before they can be switched on.
Cleaning
1Always unplug the appliance and let it cool down before you
start cleaning it.
2Clean the outside of the appliance with a damp cloth.
Do not let any water run into the appliance.
3Do not use any scouring agents or scouring pads.
Never use abrasive liquids like scouring agents, petrol or acetone to
clean the appliance.
� You can clean the outside of the UV filters with a soft cloth
sprinkled with some methylated spirits.
Storing
1Let the appliance cool down for 15 minutes before you put it
in transport position and store it.
� In the meantime, you can wind up the cord and put it in the base
of the appliance together with the remote control.
C2Make sure the cord and remote control are stored properly, as
they might otherwise get stuck between parts of the appliance
when you put the appliance in transport position. |
ACEC
