- You can interrupt the brewing process at any 8 Rinse the parts with fresh water after 8 Clean the pod holder after descaling to
time by pressing the on/off button I. If you cleaning and put them back into the machine. prevent the sieve in the centre from getting
switch the machine back on after you have clogged.
9 Clean the water distribution disc with a moist
interrupted the brewing process, the machine
cloth (Fig. 25).Frost-free storage
does not complete the interrupted brewing
Be careful when you do this. Make sure that the
cycle. If the coffee machine has already been used and
rubber sealing ring does not get stuck under the
therefore has been ushed with water, it may only
Do not remove the water reservoir during a edge of the water distribution disc. If it does, the
be used and stored in a frost-free place to prevent
brewing cycle, as this causes the machine to draw coffee machine starts to leak!
it from becoming damaged.
in air. When this happens, the next cup will only
Flushing
be partly lled.Replacement
If you have not used the coffee machine for three
You can order all removable parts from your Philips
Note: If you only get a small quantity of coffee or days, ush it with fresh water before you use it
dealer or a Philips service centre.
no coffee at all out of the machine,again. you have not
ushed the machine properly before rFlush the machine in the fst use. As a ollowing way:Environment
result, the boiler is not or not completely lled. Flush
1 Fill the water reservoir with cold water up to ,Do not throw away the machine with the
the machine properly (see chapter Preparing the
the MAX indication and put it back onto the normal household waste at the end of its life,
machine for use) before you brew another cup of
machine. (Fig. 3)but hand it in at an ofcial collection point for
coffee.
recycling. By doing this, you help to preserve
2 Put the 1-cup pod holder ° or the 2-cup
10 After use, lift the pod holder out of the the environment (Fig. 27).
pod holder °° in the machine without
machine and remove the coffee pod(s).
pod(s). (Fig. 6)guarantee & service
Be careful when you do this, for there may still be
some water/coffee on the coffee pod(s). 3 Put a bowl (with a capacity of at least If you need service or information or if you have a
1500ml) under the coffee spout to collect the problem, please consult the worldwide guarantee
Tips
water. (Fig. 8)leaet or visit our wwwwebsite at .philips.com.
, Rinse the pod holders and the coffee spout
au or www.senseo.com. You can also contact the
regularly to make sure that the coffee always 4 Press the on/off button I and subsequently
Philips Customer Care Centre in your country;
tastes optimally.press the 1-cup button ° and the 2-
?they will be happy to help you.
, The SENSEO coffee tastes best if you stir it cup button °° briey at the same
For Australia Customer Service telephone:
before you drink it. time. (Fig. 9)
Freecall: 1800 794 329
, If you intend to make another cup The machine lls itself with water from the water
?You nd the telephone numbers for other
of SENSEO coffee later, just leave reservoir. This takes some time and you will
countries in the worldwide guarantee leaet.
the coffee machine switched on. The probably not notice that this happens. After a while,
If there is no Customer Care Centre in your
machine automatically switches itself off after the machine starts to ush and switches itself off
country, turn to your local Philips dealer or contact
1 hour. (Fig. 18)after the ushing cycle.
the Service Department of Philips Domestic
CleaningDescalingAppliances and Personal Care BV nd . You
\their address and fax number in the worldwide
Never immerse the SENSEO coffee machine in Regular descaling prolongs the life of the coffee
guarantee leaet.
water. machine and guarantees optimal brewing results for ?
The purchase of the Philips SENSEO coffee
a long time. If you use the machine twice a day on
Never clean the machine by ushing it with the machine does not exhaust any of the rights of Sara
average, you must descale it once every 3 months.
lid open.Lee/Moccona or Philips under any of their patents
1 Fill the water reservoir up to the MAX nor does it confer upon the purchaser a licence
1 Always unplug the machine before you clean
indication with descaler and water according under these patents.
it.
to the instructions on the package of the
Troubleshooting
2 Clean the outside of the machine with a descaler. Then put the water reservoir back
moist cloth.onto the coffee machine. (Fig. 3)If you have a problem, you may nd the solution in
Use a descaler based on citric acid.the table below. If the table does not provide the
3 Remove the coffee spout (Fig. 19).
solution to your problem or if you have a question,
, You can disassemble the coffee spout for 2 Press on/off button I. (Fig. 10)
see the chapter Guarantee & service.
more thorough cleaning. (Fig. 20)The machine is ready for use when the indicator
light burns continuously.
4 Clean the coffee spout, the pod holders
and the drip tray in hot water, if necessary 3 Place the 1-cup pod holder ° in the coffee
with some washing-up liquid, or in the machine, preferably with a used coffee pod in
dishwasher (Fig. 21).it. Close the lid and make sure it is properly
locked.
5 Hold the cup tray in your hand while you
We advise you to put a used coffee pod in the
clean it with hot water, if necessary with
pod holder when you descale the machine. This
some washing-up liquid (Fig. 22).
pod serves as a lter to prevent the sieve in
You can also clean the cup tray in the dishwasher.
the pod holder from getting clogged with scale
To clean the cup tray, always remove it from residues.
the machine, as it might prove sharp when it is
4 Put a bowl with a capacity of at least 1500ml
handled incorrectly. Always handle it carefully.
under the coffee spout to collect the mixture
6 Clean the pod holders in hot water, if of descaler and water. (Fig. 8)
necessary with some washing-up liquid, or in
5 Press the 2-cup button °° and let the
the dishwasher. (Fig. 23)
machine operate. Repeat this until the water
Make sure the sieve in the centre of the pod
reservoir is empty. (Fig. 26)
holder is not clogged. If the sieve is clogged, unclog
\
it by rinsing the pod holder under a running tap. Never descale the SENSEO coffee machine
If necessary, use a washing-up brush or a pin to with the lid open. Make sure the lid is properly
unclog the sieve.locked.
7 Clean the water reservoir in hot water, 6 Repeat steps 1 to 5 with a new mixture of
if necessary with some washing-up descaler and water.
liquid. (Fig. 24)
7 Rinse the water reservoir with fresh water to
Note: You can remove the cover of the water reservoir remove descaler residues. Flush the machine
to clean the inside thoroughly.with fresh water at least 3 times by repeating
steps 1 to 5.
Note: If you use a washing-up brush, be careful not
, Do not rell the water reservoir with used
to damage the valve in the bottom of the water
hot water.
reservoir.
422200197772
4/6 |
ACEC
