PANEL FACILITIES
7DIRECT button/indicator0BASS tone control
Use this button when you do not wish to pass the output fromUse to adjust the low-frequency tone. The center position is
input terminal equipment through the various frequencythe flat (normal) position. When turned to the right, low-
adjusting circuits (BASS, TREBLE, BALANCE, LOUDNESS).frequency tones are emphasized; when turned to the left,
On : The indicator lights: The signals passing through thelow-frequency tones are de-emphasized.
input terminals are reproduced without passing through
the various frequency adjusting circuits. This results inNOTE:
flat, pure sound which is a more faithful reproduction ofThis control does not operate when the DIRECT button is in
the input source.the on position.
Off : The indicator goes off: The signal passes through the
various frequency adjusting circuits.
-SPEAKERS B (ON/OFF) button/indicator
Use this button to listen to the speaker system connected to
8SB MODE button/indicatorSPEAKERS B terminals.
The SB mode is a special mode in which the amplifier does notON : The indicator lights. Sound is heard from the speaker
accept remote control (But all of the facilities can be controledsystem.
by manual as same as SB mode OFF.). Fix the VOLUMEOFF : The indicator goes off. No sound is heard from the
control near the center position. In this mode, the set can bespeaker system. Set to this position when listening
used as a power amplifier which amplifies the LINE/SUR-with headphones.
ROUND BACK input (the function name is LINE/SB) with a
input sensitivity of 1 V.
=PHONES jack
For example, when the set is combined with one of PioneerOs
When using headphones, insert the plug into this jack.
Surround Back compatible receiver, the set can be used as
the Surround Back amplifier (For details, please refer to the
NOTE:
instruction manual of the receiver.)
The speakers continue to output sound even when head-
phones are plugged into this jack.
9TREBLE tone control
To mute the sound from the speakers, press the SPEAKERS
Use to adjust the high-frequency tone. The center position is
button to OFF.
the flat (normal) position. When turned to the right, high-
frequency tones are emphasized; when turned to the left,
~SPEAKERS A (ON/OFF) button/indicator
high-frequency tones are de-emphasized.
Use this button to listen to the speaker system connected to
SPEAKERS A terminals.
NOTE:
ON : The indicator lights. Sound is heard from the speaker
This control does not operate when the DIRECT button is in
system.
the on position.
OFF : The indicator goes off. No sound is heard from the
speaker system. Set to this position when listening
with headphones.
8
<ARE7263>
En
ACEC
