Section
Audio Adjustments17
2 Touch ADJ. next to SPEAKER LEVEL on! You can store the adjusted setting in memory
the sound setting menu and then touchby using MEMORY. For details concerning op-
TEST TONE.eration, refer to Storing the adjusted audio set-
The test tone is outputted. It rotates fromtings in memory on the next page.
speaker to speaker in the following sequence! The adjusted speaker output level cannot be
at intervals of about two seconds. The currentstored by each listening position. This means,
settings for the speaker over which you hearmemorizing a speaker output level for customAudioAdjustments
the test tone are shown in the display.setting overwrites the levels of all listening po-
Front left speaker?Front center speaker?sitions.
Front right speaker?Rear right speaker?Rear
center speaker?Rear left speaker?Subwoo-
ferAdjusting the speaker output
Check each speaker output level. If no adjust-levels finely
ments are needed, perform step 4 to stop the
test tone.Speaker level can be adjusted finely by listen-
# Using TEST TONE, the tweeters and the fronting to an audio output. First, use test tone to
speakers are adjusted same time. To adjust themadjust the approximate speaker level, and then
separately, please refer to Adjusting the speakeruse this function to adjust finely.
output levels finely on this page.
# The settings do not appear for speakers1 Recall the speaker output level settings
whose size is set OFF. (Refer to Customizing theyou want to adjust.
speaker setting on page 89.)Refer to Recalling the speaker output level set-
tings on the previous page.
3 Touch or to adjust the speaker out-
put level.2 Touch ADJ. next to SPEAKER LEVEL.
Each time you touch or it increases or de-3 Touch or to adjust the speaker out-
creases the speaker output level. -24dB toput level.
+10dB is displayed as the level is increased orEach time you touch or it increases or de-
decreased.creases the speaker output level. -24dB to
# The test tone rotates to the next speaker after+10dB is displayed as the level is increased or
about two seconds from the last operation.decreased.
# You cannot select speakers whose size is set
4 Touch STOP to stop the test tone out-at OFF. (Refer to Customizing the speaker setting
put.on page 89.)
Notes
Notes
! You can mute the selected speaker units by! You can store the adjusted setting in memory
touching the speaker icon (e.g., ) and thenby using MEMORY. For details concerning op-
MUTE. When muted, MUTE is displayed in-eration, refer to Storing the adjusted audio set-
stead of speaker output level. To cancel mut-tings in memory on the next page.
ing, touch the speaker icon and then MUTE.
! If needed, select speakers and adjust their ?ab-
solute? output levels. (Refer to Adjusting the
speaker output levels on the previous page.)
En93 |
ACEC
