Assembly with a separate speaker systemSpecifications
If you are using a speaker system other than the S-2EX, noteExternal dimensions ............... 400 (W) x 604 (H) x 513 (D) mm
that you will have to use a hand drill (or the like) to makeWeight .............................................................................. 17.8 kg
holes on the speaker base to secure it to the stand. Make
sure the speaker weight does not exceed 29 kg.Supplied accessories
After making holes on the speaker base where indicatedStand base plates ...................................................................... 2
(make sure they line up with the screw holes on the speakerSpeaker supports ....................................................................... 2
Stems ..........................................................................................4
support), secure the speaker to the speaker support using
commercially available wood screws as shown below.Spikes (with attached nuts) [SBA6053] ................................... 8
Spike bases [SLA1057] .............................................................. 8
Screws (Bind head, M5xL62) [SBA6050] ................................. 4
Screws (Bind head, M5xL36) [SBA6048] ................................. 4
Screws (Bind head, M6xL40) [SBA6054] ............................... 24
Spring washers [SBE6005]........................................................ 4
Washers [SBE6006] ................................................................... 4
These operating instructions [SRD6045] ................................. 1
Y Specifications and design subject to possible modifica-
tion without notice, due to improvements.
Fastening nutY The product number are listed above in square brackets.
Speaker
base
SpeakerScrew holes
supportfor securing
speaker
Replacement part numbers
Commercially Part namePart no.
Y Protector (Bottom)SHA6095
available wood
screwY Protector (Middle)SHA6096
Y Protector (Top)SHA6097
Y ProtectorSHA6098
Y Packing caseSHG6150
Y Protection sheetSHC6044
Y Protection sheetSHC6045
Cabinet and stand maintenanceY Protection sheetSHC6046
Y Use a polishing cloth or dry cloth to wipe off dust and
dirt.
Y If the cabinet or stand is very dirty, use a soft cloth
dipped in some neutral cleanser diluted 5 or 6 times
with water. Finally, wipe again using a dry cloth. Do notIf you want to dispose this product, do not mix it with
use furniture wax or cleaners.general household waste. There is a separate collection
Y Never use thinners, benzine, insecticide sprays andsystem for used electronic products in accordance with
other chemicals on or near the cabinet or stand, sincelegislation that requires proper treatment, recovery and
these will corrode the surfaces.recycling.
Private households in the 25 member states of the EU, in
Switzerland and Norway may return their used electronic
products free of charge to designated collection facilities or to a
retailer (if you purchase a similar new one).
For countries not mentioned above, please contact your local
authorities for the correct method of disposal.
By doing so you will ensure that your disposed product under-
goes the necessary treatment, recovery and recycling and thus
prevent potential negative effects on the environment and
human health.
Published by Pioneer Corporation.
Copyright ? 2005 Pioneer Corporation.
All rights reserved.
4
En |
ACEC
