Connections02
6 Switch the TV to all the other tuned4Select Setup from the HOME MENU
channels, including the channel tuned for thescreen, TV Setup, and then RF Output
VCR, and check the picture quality.Channel using 5, and SELECT
If the picture quality is good, go to thebuttons on the remote.
Starting up the first time on page 12. If thereThe default setting for this option, 38,
is a picture quality problem even though theshould be changed if there is interfer-
aerial is connected, follow the instructions
ence. Select a channel that is far from
below after completing Starting up the first38. Press the MENU button (Exit) to exit
time on page 12.the menu and store the setting.
1Disconnect the aerial from the back of5Repeat from Step 4 to check if the
the DTR.picture quality improves.
2Check to make sure the TV is tuned to
the channel selected for watching digital
programmes.
3Press the MENU button on the remote.
The HOME MENU screen is displayed.
Connecting to a digital audio device
Connect an optical digital audio cable (sold seperately) between the optical digital audio output
socket on the DTR and an optical digital input on a sampling rate converter-equipped stereo
system, AV amp, etc.
Digital Terrestrial Receiver
230V50HzVCRTVOPTICALTVAERIALY If a Dolby Digital encoded audio stream
is output and you have a Dolby Digital
decoder equipped external digital audio
device, change your digital audio output
settings in User Preferences, Digital
Sampling rate Audio Out. (See pages 27 and 28.)
converter-equipped
stereo system,Y If the external digital audio device does
AV amp, etc.not support the sampling rate at which
the digital audio is being broadcast, no
audio will be heard.
ODolby� and the double-D symbol are
trademarks of Dolby Laboratories.
11
DBR-TF100GB_09_15.p65117/22/03, 12:14 PM |
ACEC
