Section
Before You Start01
English
2 Grip the left side of the front panel andreverse, and then continue reversing every 10
pull it gently outward.seconds. Pressing BAND when power to this
Take care not to grip it too tightly or to dropunit is turned off while the ignition switch is
the front panel and protect it from contactset to ACC or ON cancels the reverse mode.
with water or other fluids to prevent perma-Press BAND again to start the reverse mode.
nent damage.
Feature demo mode
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Pressing
DISPLAY during feature demo operation can-
cels the feature demo mode. Press DISPLAY
again to start the feature demo mode. Remem-
3 Put the front panel into provided pro-ber that if the feature demo continues operat-
tective case for safe keeping.ing when the car engine is turned off, it may
drain battery power.
Attaching the front panel
% Replace the front panel by holding itUse and care of the remote
upright to the unit and clipping it securely
into the mounting hooks.control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus (-) poles pointing in the proper di-
rection.
! When using for the first time, pull out the
film protruding from the tray.
About the demo mode
This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.WARNING
Keep the battery out of the reach of children.
ImportantShould the battery be swallowed, immediately
The red lead (ACC) of this unit should be con-consult a doctor.
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicleCAUTION
battery may be drained.! Use only one CR2025 (3 V) lithium battery.
Reverse mode! Remove the battery if the remote control is not
used for a month or longer.
If you do not perform an operation within
about 30 seconds, screen indications start to
En7 |
ACEC
