PART NAMES AND FUNCTIONS
43 CH-1 effect switch and indicator49 CH-2 effect mix ratio/depth adjust dial
(EFFECT LOCK ON/OFF/ON)(MIX/DEPTH)
To turn effects [ON], either pull switch forward (switchUse to adjust the volume (amount) of effects applied to CH-2
returns automatically to [OFF] when released) or slide to far(rotate clockwise to increase effects, counterclockwise to
side to the [LOCK ON] position. When effects are [ON], thereduce).
indicator flashes and effects are applied to CH-1.
50 CH-2 effect switch and indicator
44 CH-1 TAP button(EFFECT LOCK ON/OFF/ON)
Under normal conditions, the automatic BPM counterTo turn effects [ON], either pull switch forward (switch
operates to display the trackOs BPM value on the touch panel.returns automatically to [OFF] when released) or slide to far
Automatic BPM counting may be difficult with some tracks,side to the [LOCK ON] position. When effects are [ON], the
however. In such cases, or if you wish to deliberately set aindicator flashes and effects are applied to CH-2.
different BPM, use the TAP button.
Y The BPM value can be changed by rotating the TIME/51 CH-2 TAP button
SELECT dial while holding the TAP button depressed.Under normal conditions, the automatic BPM counter
Y Tapping the button in time with the beat will cause theoperates to display the trackOs BPM value on the touch panel.
function to switch to the manual BPM count mode; the
tapped beat will be counted and displayed as the BPMAutomatic BPM counting may be difficult with some tracks,
however. In such cases, or if you wish to deliberately set a
value. Returning to the auto BPM mode is performed fromdifferent BPM, use the TAP button.
the effect parameter adjust screen (see page 16,Y The BPM value can be changed by rotating the TIME/SELECT
OAutomatic Mode BPM Counting�) .
dial while holding the TAP button depressed.
Y Tapping the button in time with the beat will cause the
45 CH-2 effect bank buttons and indicatorsfunction to switch to the manual BPM count mode; the
(BANK 1, 2, 3)tapped beat will be counted and displayed as the BPM
When one of these buttons is pressed, the indicator lightsvalue. Returning to the auto BPM mode is performed from
and the corresponding preset effect is enabled. Each BANKthe effect parameter adjust screen (see page 16,
button can be recorded with three effects for CH-2 (at time ofOAutomatic Mode BPM Counting�) .
shipping, the buttons have been factory preset with typically
used effects). BANK 1 is selected in the default condition
after power is initially turned on.
46 CH-2 effect parameter adjust button (FX ADJ.)
Press to display the touch panelOs CH-2 effect parameter
adjust menu.
47 Fader curve display and CH-2 effect select
button (FADER CURVE/BANK EDIT)
Press to display the fader curve on the touch panel. Holding
the button depressed for about one second will cause the
touch panel to display the CH-2 effect select menu.
48 CH-2 effect time adjust/select dial
(TIME/SELECT)
Use to adjust the time parameters of effects applied to CH-2
(rotate clockwise to lengthen, counterclockwise to shorten).
When the effect select menu is displayed, causes the effects
list to scroll.
11
<DRB1349> |
ACEC
