ADDITIONAL INFORMATION
TROUBLESHOOTING
If you are having trouble with the TV card, check the following items to see if the
problem can be resolved. Sometimes another device may be at fault, so be sure to also
inspect the other devices being used. If the trouble cannot be resolved, contact your
nearest PIONEER authorised service centre or your supplying dealer.
ProblemPossible Solution
EnglishCannot switch to inputs 3-5TV card is not inserted correctly, ensure card is
correctly inserted .
Remote control unit does not operateAre batteries inserted with correct polarity.
Are batteries worn out (Replace with new
batteries)
Are you using it under strong fluorescent
lighting?
Is a fluorescent light illuminating the remote
control sensor?
No PicturesIs connection to other components correct? (See
pages 8-11)
Has set-up been done correctly after connection?
(see page 27)
Is the correct input selected?
Is a non-compatible signal being connected?
Is picture adjustment correct? (See pages 20-21)
Please remove the TV Card from the Plasma,
if normal operation and picture on inputs 1 and 2
are restored the TV Card has a malfunction.
Unit cannot be operatedExternal influences such as lightning, static
electricity ,etc, may cause improper operation.
In this case turn off the power for 1-2 minutes
and try again.
Please remove the TV Card from the Plasma,
if normal operation and picture on inputs 1 and 2
are restored the TV Card has a malfunction.
Picture is cut offAre settings for picture format correctly set.
(See page13)
Green PicturesEnsure Slot interface setting is set to
COMPONENT1(refer to page7 'setting integrator
menu')
An outline of previous still imagesAfter displaying a PC image or any other still
can be seen on the screen evenimage, it is recommended to view a normal moving
when a different input is selectedpicture in the 'Wide' or 'Full' screen setting for more
than 3 times the length of the previous still image.
29ADDITIONALINFORMATION |
ACEC
