2 Installing and Connecting Up
Connecting Up the System
Important: Before making or changing any rear
panel connections, make sure that all the compo-
nents are switched off and unplugged from the power
supply.
Display unit
The CD receiver is the central component of the
system: everything else connects to it. The diagram
Display cable
left shows the tape deck connected to the CD receiver,
without the optional MD recorder or CD recorder. (If
you bought either/both of these, see their respective
CD receiver
instruction manuals for details of connecting them
to the rest of the system.)
1 Connect the display cable between the CD
receiver and display unit, taking care to connect
Tape deckthe L-shaped connector to the display unit.
2 If you also have the tape deck:
Connect it up to the CD receiver using the ribbon
Ribbon cable
cable attached to the rear of the tape deck. (See
Ribbon cables, left, for important information
System connections
on connecting/disconnecting these.)
It is possible to wall-mount the display unit using
Ribbon cables
two screws (not supplied) securely fastened to a wall.
IMPORTANT: Never connect orLine the screws up with the holes on the rear side of
disconnect the system ribbon cablesthe unit and hang the unit on the wall.
while the power plug is connected to
the wall outlet. Doing so may damage
the unit.
To insert, hold the connector and pushScrew holes for
firmly into the socket until you hear itwall-mounting
click home.
Note: Pioneer bears no responsibility for
accidents resulting from faulty assembly or
installation, insufficient mounting strength of
walls or other building fixtures, misuse or
natural disasters.
To remove, hold the connector
securely on either side with thumb andTo use the remote and display as a single unit,
forefinger and pull out from the socket.connect the two as shown below. When correctly
connected the four larger buttons light up blue.
123
8 |
ACEC
