PIONEER DV667A Instruction Manual

DV563.book 83 Z
8
?
?
?
??
?e
?
?xý~
Uxý9=
?p
?
? 
Additional information10
ProblemRemedy
No picture/No color.Y Incorrect video connections: Check that connections are correct
and that plugs are inserted fully. Also check the video cable for
damage.
Y TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
Y The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: See page 56 for how to set to
interlace.
Y When set to progressive video output, there is no video output from
the composite or S-video outputs.
Screen is stretched or Y The TV Screen setting in the Initial Settings menu is incorrect. See
aspect does not change.page 72 for how to set it correctly for your TV/monitor.
Y If your TV/monitor is connected using an S-video cable, try changing
the S-Video Out setting (page 58).
Picture disturbance Y This player is compatible with Macro-Vision System copy guard.
during playback or the Some discs include a copy prevention signal, and when this type of
picture is dark.disc is played back, stripes etc., may appear on some sections of the
picture depending on the TV. This is not a malfunction.
Y Due to the playerOs copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
Y The TV system may be set inappropriately. See Setting the TV
System on page 81.
No audio, or audio is Y No audio is output during slow motion playback or when scanning
distorted.discs other than audio CDs
Y Some DVD discs do not output digital audio: Switch your amplifier
to the player's analog outputs.
Y Check that the disc is free from dust and dirt, and that it is not
damaged (page 70).
Y Check that all interconnects are firmly inserted.
Y Check that the plugs and terminals are free of dirt, oxide, etc. and
clean if necessary. Also check the cable for damage.
Y Make sure the player's output is not connected to the amplifier's
phono (turntable) inputs.
Y Check your amplifier/receiverOs settings (volume, input function,
speaker settings, etc.).
The analog audio is OK, Y Make sure that the Digital Out setting is set to On (page 54).
but there appears to be Y Check that the Dolby Digital, DTS and MPEG out settings
no digital audio signal.(pages 55�56) are suitable for your amplifier/receiverNcheck the
instruction manual that came with your amplifier/receiver.
Y SACDs and some DVD-Audio discs do not output digital audio.
Listen through the playerOs analog audio outputs.
83
En