07 Function for Commercial Use
Command Stack Function
The DVD-V8000 is equipped with a Command Stack func-2) Use the ?, ? buttons to highlight the command
tion, allowing a series of operations (PLAY, STOP, etc.) to beyou wish to input, then press the ENTER
pre-programmed into the player. The Command Stack canbutton.
then be called up for automatic performance, or each step
1 SEGMENT PLAY:
can be called individually by the remote control unit. Also, the
Use to designate a start and stop point for frame seg-
contents of a recorded Command Stack can be preserved in
ment playback.
USB memory, and Command Stacks preserved in USB2 CHAPTER PLAY:
memory can be called up and executed.
Use to designate a start and stop point for chapter play-
back.
Important
3 COMMAND:
? The Command Stack function cannot be used with CDs
Use for commands other than 1 or 2.
and Video CDs.
? The largest stack recordable on the player is 300 steps.
2.1 SEGMENT PLAY command input
? Recorded Command Stack data is preserved in memory
Example: To play title 1, frames 301 to 513.
even when the power cord is disconnected.
1) With the cursor on [SEGMENT PLAY], press
the ENTER button.
Inputting a Command Stack
Command Stack
1. Selecting input mode
Group(1-001)Command(0-000)
At the ADV. SETUP menu select [Command Stack], or pressGroup001001SEGMENT PLAY
the remote control unitOs MEMORY button to select the in-002CHAPTER PLAY
003 COMMAND
put mode.004
005
Important006
007
? To enter the command stack input menu, a DVD disc must
008
be loaded.
MoveSelect ENTER Return RETURN ExitSETUP
Initial COMMAND STACK input menu
Command Stack2) With the cursor on [TITLE], press the numeral
Group(1-001)Command(0-000)button [1], then press the ENTER or ? button.
Group001001
? During playback, the title will be displayed.
002
0033) With the cursor on [SEARCH FRAME], press
004
numeral buttons [3], [0], [1], then the ENTER
005
006or ? button.
007? If the ENTER button is pressed during playback, the
008
frame at the point where the button is pressed will be
set as the starting point.
MoveSelect ENTERExitSETUP
4) With the cursor on [MARK FRAME], press
numeral buttons [5], [1], [3], then the ENTER
2. Entering commandsbutton or ? button.
1) Press the \ button to highlight the command? If the ENTER button is pressed during playback, the
column at the right of the menu, then pressframe at the point where the button is pressed will be
the ENTER button.set as the end point.
? As shown in the accompanying illustration, 3 selection? Once [MARK FRAME] is input, [SUBTITLE], [AUDIO],
items will be displayed.and [ANGLE] cannot be input.
5) With the cursor over [OK], press the ENTER
Command Stack
button.
Group(1-001)Command(0-000)
? Setting is complete.
Group001001 SEGMENT PLAY
002 CHAPTER PLAY
003 COMMANDCommand Stack
004Group(1-001)Command(0-000)
005Group001001
TITLE01
006002 SEARCH FRAME
000301
007003 MARK FRAME000513
008004 SUBTITLE
005 AUDIO
006 ANGLE
MoveSelect ENTER Return RETURN ExitSETUP OK CANCEL
007
008
MoveSelect ENTER Return RETURN ExitSETUP
64 |
ACEC
