Section
13Installation
ImportantDIN front/rear mount
! Check all connections and systems beforeThis unit can be properly installed either from
final installation.?Front? (conventional DIN front-mount) or
! Do not use unauthorized parts. Use of un-?Rear? (DIN rear-mount installation, utilizing
authorized parts may cause malfunctions.threaded screw holes at the sides of unit chas-
! Consult your dealer if installation requires dril-sis). For details, refer to the following installa-
ling of holes or other modifications to the vehi-tion methods.
cle.
! Do not install this unit where:
? it may interfere with operation of the vehi-
cle.DIN Front-mount
? it may cause injury to a passenger as a re-
sult of a sudden stop.Installation with the rubber bush
! The semiconductor laser will be damaged if itDashboardMounting sleeve
overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 30°.Rubber bush
Screw
! The cords must not cover up the area shown1 Insert the mounting sleeve into the
in the figure below. This is necessary to allowdashboard.
the amplifires to radiate freely.
2 Secure the mounting sleeve by using a
Do not close this area.screwdriver to bend the triangular metal
tabs (90°) into place.
! To install more securely, bend the quadran-
gular tabs as necessary.
3 Install the unit as illustrated.
! When installing, to ensure proper heat disper-
sal when using this unit, make sure you leave
ample space behind the rear panel and wrap
any loose cables so they are not blocking theRemoving the unit
vents.1 Extend top and bottom of the trim ring
outwards to remove the trim ring. (When
reattaching the trim ring, point the side
with a groove downwards and attach it.)
! It becomes easy to remove the trim ring if
the control panel is released.
40En |
ACEC
