PIONEER DVR510H Instruction Manual

DVR-03_HDD_KU.book 25 Z
8
?
?
?
??
?e
?xý
Å 
Uxý9 V
?
?p
?
? 
Getting started04
Use the / (cursor up/down) buttons to select 12 ThatOs it! Press ENTER to finish setting up, or
Compatible, Not Compatible, or DonOt Know, then select �Go BackO if you want to start again.
press ENTER.
" Note that progressive scan video is only output Initial Setup
through the component video outputs (see page 14).BasicClock Set
TunerOn Screen DisplaySetup is complete!
Video OutFront Panel Display
9 Is this recorder connected to an AV receiver for Enjoy using your DVD recorder!
Audio InRemote Control Set
digital audio?Audio OutSetup MavigatorSetup MavigatorFinish Setup
LanguageGo Back
Recording
Playback
Initial Setup
BasicClock SetAV Amp Digital Connect
TunerOn Screen Display
Video OutFront Panel DisplayOther settings you can make
Audio InRemote Control SetConnected
Audio OutSetup MavigatorSetup Mavigator Not ConnectedAfter setting up using the Setup Navigator, you should be
Language
Recordingready to start enjoying your DVD recorder. Its possible,
Playbackhowever, that you may want to make a couple of
additional settings, depending on how the recorder
Use the / (cursor up/down) buttons to select tuned into the terrestrial TV channels.
Connected, or Not Connected, then press ENTER.
" Manual channel setting This setting lets you skip
" If you select Not Connected, that completes the channels where there is no station, as well as
setup. Press ENTER to exit the Setup Navigator, or manually tune to stations. See Manual CH Setting on
select Go Back if you want to go back and start again.page 91.
10 Select the digital audio formats your AV receiver " VCR Plus+ channel setting This setting lets you
is compatible with.assign guide channels to ensure that the VCR Plus+
programming system works correctly. See VCR
Plus+ CH Setting on page 91.
Initial Setup
BasicClock SetAV Amp CompatibilityThat completes basic setup using the Setup Navigator.
TunerOn Screen Display
Video OutFront Panel Display" Setting up the remote to control your TV You can set
Remote Control SetAudio InDolby Digital
Audio OutDolby Digital,DTSup the supplied remote control to control many Setup MavigatorSetup Mavigator
LanguagePCM onlybrands of TV. See Setting up the remote to control your
Recording
PlaybackTV on page 101.
Use the / (cursor up/down) buttons to select Dolby
Digital, Dolby Digital, DTS or PCM only, then press
ENTER.Selecting the hard disk or DVD for
" Check the operating instructions that came with your
playback and recording
AV receiver if youre not sure what its compatible
The HDD and DVD buttons on the remote control and the
with.
HDD/DVD button on the front panel are used to select
11 Is your AV receiver compatible with 96 kHz the hard disk (HDD) or DVD for playback and recording.
digital audio?The indicator in the front panel display shows which is
currently selected.
Initial Setup
BasicClock Set96kHz PCM Compatible
TunerOn Screen Display
Video OutFront Panel Display
Audio InRemote Control SetCompatible
Audio OutSetup MavigatorSetup MavigatorNot Compatible
LanguageDon't Know
RecordingHDDDVD
Playback
Use the / (cursor up/down) buttons to select
Compatible, Not Compatible, or DonOt Know, then
press ENTER.
" Check the operating instructions that came with your
AV receiver if youre not sure.
25
En