aallffaatteeccEnglish
6
Dustbag indicator and changing the dustbag
For peak performance the dustbag should be changed when full.Troubleshooting
The mechanical dustbag indicator window will gradually turn redPower: if the electric power does not come on, disconnect from
Accessories Getting Started
when filling and completely red when full. mains and check plugs, cable and fuses where appropriate.
Dustbag1 Check that the dustbag is in place.If the dustbag should get broken in the cleaner, take cleaner toThe cleaner may switch itself off in event of severe blockage or
Swivel hose and handle with manual suction control 2 Insert the hose until the catches click to engage service centre for cleaning. This is not covered by the guarantee.excessively dirty filters. In such cases, disconnect from mains
press catches inwards to releaseThe dustbag full indicator may signify that the bag is blockedand allow to cool for 30 minutes. Clear blockage and/or replace
Combination carpet/hard floor nozzle3a,b Attach the telescopic tube to the hose handle and the flooroccasionally caused by finer dustfilter(s) and restart.
Narrow crevice nozzle nozzle by twisting them together (twist and pull apart toand may result in overheating. If this occurs change the bag even ifThe clearing of blocked hoses is not covered by the guarantee.
dismantle).it is not full. DO NOTVACUUM VERYFINE DUST(PLASTER,To avoid blockages and maintain suction efficiency, the floor
Upholstery nozzle
4 Extend the cable and connect to mains, ensuring the cable isCEMENT, COLD CINDERS...).nozzles should be cleaned regularly using the hose handle.
Dusting brushnot twisted before use (Press cable rewind button to rewindTo check the dustbag, the cleaner must be switched on, with allWater: if water is sucked into the cleaner the motor must be
Telescopic tube cable. Please hold the plug to prevent it striking you).attachments connected but the nozzle does not have to bechanged at a service centre. This is not covered by the
5 Press the on/off button to start the cleaner.placed on the floor.guarantee.
6 To increase/decrease suction, adjust the rolling wheel control.
Ensuring your safetySuction can also be regulated on the hose handle byTo change the dustbag:
opening/closing the vent.7 After removing the flexible hose, open the front cover using the
The cleaner is for domestic use only and has been designed to ensure
compartment open button.
maximum safety and performance. Please follow these simple
precautions:a8 Rotate the support of the bag to the vertical position.
Features of the rangeRemove the dustbag and insert a new one.
The cleaner is double insulated so it must not be earthedAMains cable 7 Close the cover by pressing down until it clicks.
The cleaner is only to be used by adultsBCable rewind button
We recommend the dustbag is changed after using a carpet
Always store in a dry placeCMechanical dustbag full indicator
cleaning powder or if there is a bad smell from the cleaner.
Do not use to pick up liquidsDHose connection
Note: Only use original dustbags and filters
Avoid sharp objectsECarrying handle
Do not pick up hot cinders or lighted cigarette ends
FCover release catch for dustbag compartmentRef.: T153F/BT153
Do not use near flammable gasesGCover release for accessory compartment
Avoid tugging on the mains cable and check cable regularly forDustbag safety device
HOn/off button
damageTo avoid damaging the cleaner, do not use it without a dust bag. A
IParking position for tube and nozzle when in use
Note: Do not use cleaner with a damaged cable. safety device is fitted which prevents the cover closing without a
JStorage slot for tube and nozzle when not in use
If damaged the cable should be replaced at a service centre dust bag in place. Do not attempt to force cover shut.
The plug must be removed from the socket-outlet before cleaningK Suction control regulatorChanging/cleaning the filters
or maintaining the applianceNever use the cleaner without the filters in place.
The filters should be changed/cleaned approximately every fifth
All service and repairs must be carried out by authorised service
dust bag.
staff
Getting the best resultsTo clean the motor protection filter:
9 Pull dustbag upward and remove the motor protection filter.
Carpets: Use floor nozzle with lever in this position.
14 Rinse the filter under tap water and dry it completely.
Hard floors: Use floor nozzle with lever in this position.9 Put the filter back into the cleaner and close the cover.
Loose rugs/curtains/lightweight fabrics: Reduce the suction
power. Use the floor nozzle for loose rugs and the upholsteryTo clean the exhaust filter:
nozzle for curtains, cushions etc.10-11 Open the filter grill and remove the exhaust filter.
14 Rinse the filter under tap water and dry it completely.
Confined areas: Use the crevice nozzle for tight corners and11-10 Put the filter back into the cleaner and close the filter grill.
radiators etc.
Above the floor surfaces and some upholstered furniture:
Use the dusting brush. |
ACEC
