Open both the appliance door and that of the
kitchen unit to appro°. x. 90
Place the little plates over the runners. Hold the Fig. 10
doors of the appliance and the unit together and 8mm
mark the holes.
Remove the little plates and make the holes with PR34
a diam. of 2 mm. Replace the little plates over Fig. 11
the runners and screw in the screws provided
(3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes.
At the end of the procedure, check that the doors
of the appliance and the kitchen unit open
properly.
PR35
Inner door reversalFig. 12
Using a screwdriver release bracket (1) by
pressing on the internal spring (Fig. 12) and
withdraw it from its seat together with the door;
remove plug (2) and Ţt it in the hole left open on 180!
the opposite side;2
turn the door through 180°, remove the bracket 1
(1) and reŢt it on the opposite side.
ReŢt the door and insert the top pin and bottom PR140
bracket (1), pushing it into place.
To ensure correct storage of food, the door is
Å¢tted with a simple spring device which holds it in
the open position until it is properly closed.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary? b6% of the ry ated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.
TECHNICAL SPECIFICATIONGB
The technical data is indicated in the rating plate on the left side inside the appliance.
6 |
ACEC
