ROLAND AT-90SL Instruction Manual

AT-90SL_e.book 205 Z
8
?
?
?
??
?e
?xýI
Uxý9=
?p
?
? 
Chapter 11 Connecting with External Device
Connecting to Audio
Input switch
Effect
Equipmentposition
The sound of the external device will be
When you connect the AT-90SL to audio equipment, you can Normal
heard without modification.
play the sounds from the AT-90SL through the speakers on
the audio equipment or record your performances on a tape The RSS reverb of the AT-90SL will be
RSSapplied to the sound of the external
recorder or other recording device.
device.
When connecting, please use an audio cable with a standard
If the Input switch is set to ORSS,� you can use the AT-90SLOs
phone plug, such as the PCS-100PW (sold separately). When
[Master Volume] slider to adjust the volume of the external
purchasing an audio cable, please consult the vendor where
device.
you bought the AT-90SL.
NOTE
Connectors
If the Input switch is set to ORSS,� RSS reverb will also be
Output Jacks
applied to the sound of the microphone. In this case, use the
You can connect audio equipment using audio cables (sold
[Mic Volume] knob to adjust the microphone volume.
separately) and play the sounds from the AT-90SL through
the speakers on the connected equipment or record your
Making the Connections
performances on a tape recorder or other recording device.
If the input of the connected device is monaural, you must
use the L (mono) jack.When connecting, turn on power to your various devices in
fig.
the order specified. Failure to follow these steps in the order
Outputgiven could cause a malfunction and/or damage to speakers
MainAux
or other equipment.
L(mono)RL(mono)R
Playing Sounds from the AT-90SL Through the
Speakers on Audio Equipment or Recording
Your Performances on a Recording Device
1.Turn the volume all the way down on the AT-
90SL and on the device youOre about to connect.
Input Jacks2.Turn off the power to the AT-90SL and other
You can connect another sound module, such as audio connected equipment.
equipment or an electronic instrument using audio cables
3.Use audio cables (sold separately) to make the
(sold separately) and play the sounds from the connected
connection.
device through the speakers on the AT-90SL.
If the input of the connected device is monaural, you must 4.Switch on the AT-90SL.
use the L (mono) jack.
5.Switch on the connected device.
fig.
Input6.Adjust the volume level on the AT-90SL and the
connected device.
NormalL(mono)R
RSS
Recording AT-90SL Performances on a
Recording Device
7.Start recording with the connected device.
When using the Input jacks to play the sound from an
external device through the speakers of the AT-90SL, you can 8.Play the keyboard of the AT-90SL.
apply the internal RSS reverb of the AT-90SL (p. 210).
9.When the performance ends, stop recording on
the connected equipment.
205