Playing the pad samples
Basic ways to play samples
Playing a sample
Press a pad in which a sample has been recorded (lit), and it will play.Depending on the status of the
audio tracks, even pads that
There are 3 kinds of how a pad starts/stops sounding. For details refer to OChanging contain samples may be
how a pad starts and stops soundingNPad Play� (p. 70).extinguished, and will not be
playable. For details refer to
Adjusting the Overall Sample VolumeOPlaying pads while audio
The overall monitoring volume of the samples you play from the pads can be tracks play back� on this page.
adjusted by the PAD/SEQ LEVEL fader and the MASTER fader.
To adjust the volume of an individual pad sample, refer to OAdjusting the volume of
a sample�Sample Level� (p. 76).Playing the pad samples
Playing samples simultaneouslyThe number of samples that
can be played simultaneously
Up to four samples can be played simultaneously. If you press more than four pads, will not increase even if you
the sample of the pad you pressed last will be given priority, and the sample of the sample in mono. However,
pad that was pressed first will stop sounding. mono sampling uses only half
the memory of stereo
Playing pads while audio tracks play backsampling.
The number of sounds that can be played simultaneously is four stereo notes total
for the audio tracks, pads, and sequence track. Audio track playback takes
priority over pad playback. This means that if seven or more audio tracks are
playing, pressing a pad will not sound its sample (the pads will be extinguished).
If you wish to play back audio tracks and add samples played from the pads,
the [STATUS] of at least two audio tracks must be extinguished (muted). In this
case, you must turn off the audio track [STATUS] in a combination of 1-2, 3-4,
5-6, or 7-8.
Playing pads while you play back an audio CD
When [SEQ PLAY] lights, an
Sample data assigned to pads will remain in the internal memory of the CDX-1
audio CD is inserted, and the
unless mixdown (p. 133) is performed or the power is turned off (p. 34). HereOs how Sequence function will
you can use the Pad/Sequence in internal memory to play the pads while an audio automatically be turned off.
CD plays back.Also, when you press
[SEQ PLAY] turn on, an audio
1. With samples assigned to the pads (pads lit), insert an audio CD.CD will not be played back
even if an audio CD is
2. Press PLAY [].inserted.
The audio CD plays.
3. When you press a pad, its sample will play.
At this time you can play up to three pads simultaneously.
Can I layer samples from another pad bank?
When you switch pad banks, the samples of the previous pad bank will stop.
However, samples to which Hold (p. 72) is applied will continue to sound until Hold
is defeated. You can press other pads to layer samples from another sample bank.
Even in this case, it is not possible to exceed the limit of four stereo notes.
69 |
ACEC
