CUBE-20X_e.book 8Z8 ???-??e??xýe
Uxý9=?p??Â
Panel descriptions
16.RECORDING OUT/PHONES JackTUNING
When Using RECORDING OUT
You can use Omanual tuning,� whereby you switch to each
Use mono 1/4� phone plugs when
connecting to this jack.individual string to tune it separately, and Ochromatic
tuning,� which automatically determines the closest pitch to
Volume level of RECORDING
OUT can be easily adjusted if you that played by the string.
set the CLEAN or LEAD channel Tuning in OManual Mode�
VOLUME as shown in the diagram 1.Press the TUNER switch.
on the right.2.Use the Type switch to select the name of the string you
When Using Headphoneswant to tune, then play a single note on the open string.
* No sound is played through the unitOs speaker while the tuner
Connect headphones to this jack.function is in use.
* No sound is played through the unitOs speaker while the
RECORDING OUT/PHONES jack is in use.
17.POWER Switch
This switches the power on and off.
* This unit is equipped with a protection circuit. A brief interval
Type Switch PositionString Name
(a few seconds) after power up is required before the unit will
operate normally.6EOpen sixth string
5AOpen fifth string
* If you need to turn off the power completely, first turn off the 4DOpen fourth string
POWER switch, then unplug the power cord from the power 3GOpen third string
outlet. Refer to OPower Supply� (p. 5).2BOpen second string
1EOpen first string
* Reference Pitch: A4=440 Hz
3.Tune the string until the green indicator lights.
<The Pitch is flat> <The Pitch is flat, but almost in tune>
* When the pitch is even
lower, the indicator flashes.
<The Pitch is correct>
<The Pitch is sharp, but almost in tune> <The Pitch is sharp>
*When the pitch is even
higher, the indicator flashes.
Tuning in OChromatic Mode�
1.Hold down the TUNER switch for at least one second
so that the red indicator flashes.
2.Play a single note on the open string you want to tune.
3.Tune the string until the green indicator lights.
8 |