ROLAND CUBE-30X Instruction Manual

CUBE-30X_e.book 4Z
8
?
?
?
-?
?e
?
?xýe
Uxý9=
?p
?
? 
013
Y In households with small children, an adult
Placement
should provide supervision until the child is 351
capable of following all the rules essential for the Y Using the unit near power amplifiers (or other equipment
safe operation of the unit.
containing large power transformers) may induce hum. To
alleviate the problem, change the orientation of this unit;
..........................................................................................................or move it farther away from the source of interference.
014352a
Y Protect the unit from strong impact.Y This device may interfere with radio and television reception.
(Do not drop it!)Do not use this device in the vicinity of such receivers.
352b
..........................................................................................................Y Noise may be produced if wireless communications devices,
015such as cell phones, are operated in the vicinity of this unit.
Y Do not force the unitOs power-supply cord to Such noise could occur when receiving or initiating a call, or
share an outlet with an unreasonable number of while conversing. Should you experience such problems,
other devices. Be especially careful when using you should relocate such wireless devices so they are at a
extension cordsNthe total power used by all devices you greater distance from this unit, or switch them off.
have connected to the extension cordOs outlet must never 354b
Y Do not expose the unit to direct sunlight, place it near
exceed the power rating (watts/amperes) for the devices that radiate heat, leave it inside an enclosed
extension cord. Excessive loads can cause the insulation
on the cord to heat up and eventually melt through.vehicle, or otherwise subject it to temperature extremes.
Also, do not allow lighting devices that normally are used
while their light source is very close to the unit (such as a
..........................................................................................................piano light), or powerful spotlights to shine upon the
016
Y Before using the unit in a foreign country, consult same area of the unit for extended periods of time.
with your retailer, the nearest Roland Service Excessive heat can deform or discolor the unit.
355b
Center, or an authorized Roland distributor, as Y When moved from one location to another where the
listed on the OInformation� page.temperature and/or humidity is very different, water
droplets (condensation) may form inside the unit. Damage
..........................................................................................................or malfunction may result if you attempt to use the unit in
026this condition. Therefore, before using the unit, you must
Y Do not put anything that contains water (e.g., allow it to stand for several hours, until the condensation
flower vases) on this unit. Also, avoid the use of
insecticides, perfumes, alcohol, nail polish, spray has completely evaporated.
cans, etc., near the unit. Swiftly wipe away any liquid that 356
Y Do not allow rubber, vinyl, or similar materials to remain
spills on the unit using a dry, soft cloth.on the unit for long periods of time. Such objects can
discolor or otherwise harmfully affect the finish.
..........................................................................................................359
Y Do not paste stickers, decals, or the like to this instrument.
Peeling such matter off the instrument may damage the
exterior finish.
360
Y Depending on the material and temperature of the surface
on which you place the unit, its rubber feet may discolor
or mar the surface.
You can place a piece of felt or cloth under the rubber feet
to prevent this from happening. If you do so, please make
sure that the unit will not slip or move accidentally.
101aYThe unit should be located so that its location or
position does not interfere with its proper ventilation.
..........................................................................................................
102a
YAlways grasp only the plug on the power-supply cord
when plugging into, or unplugging from an outlet.
..........................................................................................................
103a
Y At regular intervals, you should unplug the
power plug and clean it by using a dry cloth to
wipe all dust and other accumulations away from
its prongs. Also, disconnect the power plug from the
power outlet whenever the unit is to remain unused for
an extended period of time. Any accumulation of dust
between the power plug and the power outlet can result
in poor insulation and lead to fire.
4