Attaching to a StandOutput Jack Corresponding Play Tones
MethodsSounded
Attach the CY-12R/C with the optional cymbal mount (MDY
BOW/BELLBow Shot (p. 6)Head
series), or drum stand cymbal mount (MDS series).
Bell Shot (p. 6)Rim
1. Use a commercially available drum key to Choke (p. 7)�
tighten the stopper bolt.BOW/EDGE Bow Shot (p. 6)Head
The stopper keeps the CY-12R/C from turning, and Edge Shot (p. 6)Rim
prevents the cables from catching or getting tangled on the Choke (p. 7)�
stand.
fig.01.e
If you are using the TD-10 + TDW-1 with V-Cymbal Control,
you can use both the BOW/BELL and BOW/EGDE output
StopperTighten the bolt with jacks at the same time (Three Way Triggering). For more
(Be sure toa commercially available
details, refer to OIf Using TD-10 + TDW-1 with V-Cymbal orient it correctly)drum key
Control� (p. 6).
Making the Connections
To prevent malfunction and/or damage to speakers or other
2. Attach the CY-12R/C so the unit is oriented as
devices, always turn down the volume, and turn off the power
shown in the diagram (bolt should be opposite on all devices before making any connections.
the output jacks).
1. Use the included cable to connect one of the CY-
3. Tighten the wing nut to obtain the desired 12R/COs output jacks (either one, but not both,
movement.EXCEPT when using with the TD-10 + TDW-1
Use the included felt washer and the wing nut.
with V-Cymbal Control installed) to the drum
fig.02.e
sound moduleOs trigger input jack.
Connect the L-shaped plug of the included cable to the
Wing NutCY-12R/C. This will prevent strain from being applied to
the CY-12R/C.
Felt Washer
To make use of edge shot and choking play techniques,
you'll need to connect to a trigger input jack on the
Y Double sounding may occur if the wing nut is loose.percussion sound module that accommodates rim shots.
Y Do not use the washer or felt included with the cymbal The TD-8's O1/2 (KICK 1/2)� and O11/12 (AUX 1/2)� do
mount (MDY series).not support rim shots.
2. Secure the cable with cable ties.
Leave enough slack so that the cable is not pulled by any
Connecting to
shaking or vibration of the cymbal when it is struck.
a Percussion Sound Modulefig.CY03.e
Wind the cable
(TD-6, TD-8, TD-10, etc.)
tie twice
About the Output Jacks
The CY-12R/C features two different output jacks, BOW/BELL Tighten it Leave some
not to slip
and BOW/EDGE.slack in
Use the BOW/BELL output jack when you want to play the the cable
bow and the bell sounds; use the BOW/EDGE output jack
when you want to play the bow and the edge sounds.
Turn back
to fix the
Use either the BOW/BELL or BOW/EGDE output jack, but cable
Secure the cable in place
not both at the same time (except for the TD-10 + TDW-1 with
with the cable tie
V-Cymbal Control).
Connecting both jacks results in two separate trigger inputs
playing simultaneously.Take care to ensure that the cable does not come into
contact with the cymbal or stand. Contact between the
cable and the cymbal or stand can result in problems,
5
Next |