PD/CY/KD/FD-8_e 9 Z8 ???? ??e? xý~
U xý9 V?p?? Â
KD-8
Adjusting the Foot Plate Height
Depending on your kick pedal, it can be unstable when you Y Install the kick pedal securely.
attach it to the KD-8. Be sure to adjust the foot plate height so
Y Take care not to pinch your fingers.
that the entire bottom surface of the pedal is attached to the Y The tips of the anchor bolts are sharp. Handle with care.
floor.Y When moving the setup, be sure to remove the screws
and fold the stand. Transporting the KD-8 while it
remains open may subject the stand to excessive strain
and result in damage to the stand.Beater
Adjusting the Anchor Bolts
Commercially Available Kick Pedal
When using the kick pedal on a carpet or similar surface, adjust
the anchor bolts so their tips protrude from the plate and secure
the pedal in place; this will make it easier to use the kick pedal.
* Adjust the height so that the entire pedal comes However, when used on flooring, the anchor bolts may
into contact with the floor.damage the floor. Adjust the anchor bolts correctly.
1.Loosen the standOs anchor bolts and remove
Adjusting the Anchor Bolts
the foot plate.
When Using on the CarpetWhen using on the Floor
Y The tips of the anchor bolts are sharp. Handle with care.
When Using a Twin Pedal
2.Set the kick pedal so that the entire bottom
surface is attached to the floor.Position the two beaters equally
apart from the center of the pad as
3.In most cases, the stand becomes somewhat shown in the figure at left. If one of
floated. Tighten the anchor bolts securely there the beater is further away from the
to fix the stand and foot plate.center than the other, the sound from
the further beater will be lower in
volume, or will not sound as desired.
This hight will vary depending
on your kick pedal.
Using a twin pedal will result in
lower sensitivity as compared to
when a single pedal is used. Raise the
sensitivity on the sound module.
9 |
ACEC
