Names of things and what they do
4. INPUT 3/4
These are high impedance jacks that allow a guitar or bass to be connected.
SENS knobs
These knobs adjust the input level.
Peak indicators (PEAK)
These indicators will light in red at a point -6 dB below the level at which
distortion begins. Adjust the SENS knobs so that the peak indicators do not
light.
5. INPUT 5/6
SENS knob
This knob adjusts the input level of the rear panel TRS balanced inputs (5/6).
Peak indicator (PEAK)
This indicator will light in red at a point -6 dB below the level at which
distortion begins. Adjust the SENS knob so that the peak indicators do not
light.
6. INPUT 7/8
This is an optical digital input jack that allows input from a CD/MD/DAT.
DIGITAL/ANALOG select switch
This switches between the rear panel TRS balanced inputs (7/8) and the
optical/coaxial digital inputs.
SENS knobIt is not possible to adjust
If the select switch is set to the ANALOG position, this knob adjusts the input the input level from the
level of the rear panel TRS balanced inputs (7/8).digital input jacks. You
Peak indicator (PEAK)must adjust the output
This indicator will light in red at a point -6 dB below the level at which distortion level of the playback
device.
begins. Adjust the SENS knob so that the peak indicators do not light.
7. Headphone jack
Headphones can be connected here. At the default settings, the input from
INPUT 1/2 will be monitored, but you can change the Control Panel settings
(described later) to switch the input jacks that will be monitored. For details
on the Control Panel, refer to DA-PCI Control Panel (p. 32).
8. Headphone volume knob
This knob adjusts the volume of the headphones.
9. OUTPUT indicators
When audio data is being output from the DA-2496, the corresponding
output indicators will light to show the level.
10. Power switch
fig.1-01aEThis turns the power of the DA-2496 on/off. Lower positionUpper position
The power is on when the switch is pressed ONOFF
in, and off when the switch is in the outward
position. When the power is on, the indicator
at the upper left of the power switch will light
in green.
11 |
ACEC
