Panel descriptions
D-BASS 115X Control Panel
fig.02-01
7654321
INPUTSUB OUT
Q: The volume level of the instrument connected to the D-BASS 115X 115X
is too low.
A: Could you be using a connection cable that contains a resistor?
D-BASS 115XD-BASS 210 or 115Use a connection cable that does not contain a resistor.
1. INPUT Jack3. MODE Switch
Connect a D-BASS 210/115 or other bass amp or device This switches the unit between Full Range mode and Sub
here.Woofer mode. The color of the indicator tells you which
Connect to the SUB OUT jack when connecting a 210/mode is selected (Full Range: green; Sub Woofer: red).
115.Select the mode to suit the bass you are connecting and
The SUB OUT volume is linked to the VOLUME knob, your playing conditions.
allowing you to control the volume of the 115X with the FULL RANGE:
210/115 VOLUME knob. In this case, the volume balance
All frequency ranges from low to high are output by the
between the D-BASS 210/115 and the 115X remains unitOs speakers
unchanged. When connecting another type of bass amp,
use the LINE OUT jack.Using this together with the D-BASS 210/115 produces a
powerful, punchy sound.
* This jack is designed for connections with line-level output
SUB WOOFER:
devices. You cannot connect a bass directly to this jack.
The 115XOs speakers output sounds only in the bass
range.
2. THRU OUT JackAdding an additional layer of low-frequency sound to
Signals input via the INPUT jack are output without any
the output from the D-BASS 210/115 allows you boost
change to the signal.the extreme low end even more.
Use this jack when connecting additional D-BASS 115Xs
or other powered speakers. When connecting D-BASS 4. TWEETER Knob
115Xs, connect the THRU OUT of the first D-BASS 115X
to the INPUT jack of the second.This adjusts the tweeter volume level when the 115X is
used in Full Range mode.
You can connect a third 115X to the second one, a fourth
to the third one, and so on, connecting as many units as No sound is output from the tweeter when this is turned
to the very left.
needed, thus allowing you to set up a high-power
system matched to venues of any size.* This is disabled in Sub Woofer mode.
* No signal is output from the THRU OUT jack when the power
is switched off.
* The 115XOs switch and knobs do not affect THRU OUT.
15 |
ACEC
