DP-900_e.book 7 Z8 ???? ???e?? xýe
U xý9=??p?? Â
Introduction
2.Secure the right side board to the speaker box 5.Put the Pedal Board on the stabilizer.
with the screws (in two places).When putting the Pedal Board on the stabilizer, first
fig.st2.eloosen the screws securing the speaker box to the side
Attachment screwboards.
fig.st5.e
Loosen the screws
(in four places).
Side board right
3.Set the stabilizer in the holes in the side boards Pedal Board
(in six places).
fig.st3.e
6.Secure the Pedal Board to the side boards with
the attachment screws (in two places).
StabilizerRetighten the screws loosened in Step 5.
screwsfig.st6.e
Take care not to attach the left and right stabilizer to the Attachment
wrong sides.screws
fig.st900SAP
To stabilize the pedals
Temporarily loosen the screws that fasten the pedal board.
Step on the pedal, and after verifying that the pedal is in firm
contact with the floor, re-tighten the screws firmly.
4.Raise the entire assembly.
When standing the assembled unit up, grasp near the
speaker box and center part of the DP-900, and gently
raise the assembly.
fig.st4
7 |
ACEC
