PD/CY/KD/FD-8_e 3 Z8 ??????e?xý~
Uxý9 V?p??Â
104118
Y Try to prevent cords and cables from Y Should you remove nuts, washers, screws,
becoming entangled. Also, all cords and anchor bolts, etc., make sure to put them in a
cables should be placed so they are out of the safe place out of childrenOs reach, so there is no
reach of children.chance of them being swallowed accidentally.
................................................................................................................................................................................................
106
Y Never climb on top of, nor place heavy
objects on the unit.
................................................................................................
IMPORTANT NOTES
291a
In addition to the items listed under OUSING THE UNIT SAFELY� on page 2�3, please read and observe the
following:
Placement402
Y Never use benzine, thinners, alcohol or solvents of
354bany kind, to avoid the possibility of discoloration
Y Do not expose the unit to direct sunlight, place it and/or deformation.
near devices that radiate heat, leave it inside an
enclosed vehicle, or otherwise subject it to temper-
ature extremes. Also, do not allow lighting devices
Additional Precautions
that normally are used while their light source is
very close to the unit (such as a piano light), or 553
powerful spotlights to shine upon the same area of Y Use a reasonable amount of care when using the
the unit for extended periods of time. Excessive heat unitOs buttons, sliders, or other controls; and when
using its jacks and connectors. Rough handling can
can deform or discolor the unit.
lead to malfunctions.
355b
Y When moved from one location to another where the 556
temperature and/or humidity is very different, water Y When connecting / disconnecting all cables, grasp
droplets (condensation) may form inside the unit. the connector itselfNnever pull on the cable. This
Damage or malfunction may result if you attempt to way you will avoid causing shorts, or damage to
the cableOs internal elements.
use the unit in this condition. Therefore, before using
the unit, you must allow it to stand for several hours, 558d
until the condensation has completely evaporated.Y This instrument is designed to minimize the
356extraneous sounds produced when itOs played.
Y Do not allow rubber, vinyl, or similar materials to However, since sound vibrations can be transmitted
remain on the unit for long periods of time. Such objects through floors and walls to a greater degree than
can discolor or otherwise harmfully affect the finish.expected, take care not to allow these sounds to
become a nuisance to neighbors, especially when
performing at night and when using headphones.
Maintenanceadd
Y The padOs rubber surface may turn white, but this
401ahas no effect on the padOs function.
Y For everyday cleaning wipe the unit with a soft, dry
cloth or one that has been slightly dampened with
water. To remove stubborn dirt, use a cloth impreg-
nated with a mild, non-abrasive detergent. After-
wards, be sure to wipe the unit thoroughly with a
soft, dry cloth.
3 |