9Changing the receiving frequency
To change the receiving frequency, please proceed with the following steps:
Press button (OSETO). The text OFREQUENCY MHZ� in display panel begins to flash.
With buttons (/) you can now select a different frequency. The display always jumps
to the next fixed frequency setting in the program. 8 channels are allocated to each range.
The 4 possible ranges are always shown by the display in display panel .
Have you set the frequency correctly? Then press button (OSETO) again for about 3
seconds. Your entry is confirmed by the fact that the text OFREQUENCY MHZ� ceases to flash. At
the same time, OS`BO appears and the other displays in display panel go off briefly.
Only now does the receiver change to the new frequency, any existing RF link to a
transmitter on the previous frequency is interrupted.
You can discontinue your entry at any time by briefly pressing button (OSETO). The cancellation
is briefly confirmed on the display panel with OESCO. The receiver switches back to normal
operation and the text OFREQUENCY MHZ� ceases to flash. The frequency to which the receiver was set
appears again.
After about 5 seconds, the receiver then automatically returns to normal operation if no entry has
been made during this period. Here, too, OESCO flashes briefly. You must then begin operation over
again.
39 |
ACEC
