Operation of Remote Control (Continued)
L HOW TO IDENTIFY A CABLE CONVERTER
L To Identify Your Cable Converter �DirectCATV CONVERTERREMOTE CONTROL
BRANDCODE NUMBER
Entry Method.
Use the following steps and list to quickly findAnvision07, 08
the remote control code for your cable TVCable Star07, 08
converter.Eagle08
Y First look up your converterOs remote codeGeneral Instrument04, 05, 15, 23, 24, 25,
number before going through the direct code30, 36
Jerrold04, 05, 15, 23, 24, 25
entry steps below.
30, 36
Y If this procedure does not identify yourMagnavox07, 08, 19, 25, 28, 29,
converter, use the Search method for32, 33, 40, 41
identification.Oak Sigma18
(1) Slide CATV /DVD-TV/VCR switch to CATV.Panasonic27, 39
(2) Press and hold down DISPLAY and CHPhilips07, 08, 19, 26, 28, 29,
DOWN (9) on your remote control.32, 33, 40, 41
Pioneer18, 20
Then release both buttons.
Randtek07, 08
(3) Within ten seconds after releasing DISPLAY
RCA27, 43
and CH DOWN (9), enter your converterOsScientific Atlanta03, 22, 42
two-digit code number using REMOTESony44
KEYPAD (refer to list).Viewstar07, 08, 19, 26, 28, 29
Y The remote control is now ready to send32, 33, 40, 41
Zenith14
commands to your converter.
Y Some brands have more than one remote
TIPS ON IDENTIFYING YOUR CABLE
code listed due to changes in the remote codes
from early to later model years. In such cases,CONVERTER:
Be Patient: a minute or two can seem a lot
you may have to try more than one code to
longer when youOre waiting for something to
find the code your converter accepts.
happen, but the code should be identified
Note:within 2 minutes. Remember, it is only a one-
Depending on the model, year produced,time set-up.
Be careful not to let the CATV converter scan
brand, and type of CATV converter, some
more than five channels when the indicator
models may not be compatible with the remote
starts to move up. If you continue holding down
control.
the DISPLAY and CH UP (8) after five channel
L To Identify Your Cable Converter � Searchscans, the proper remote code can be passed
up, and the two minutes identify cycle will have
Method.
to be repeated.
(1) Slide the CATV /DVD-TV/VCR switch to CATV.
If a channel change does not occur on the
(2) Press the POWER button on the cable
converter to ON.cable converter within two minute, read the
identifying instructions again and repeat the
(3) Stand at least six feet away from the converter.
steps. Should a channel change still not occur,
Point the remote towards the converter.
the remote will not operate with the desired
Hold down the DISPLAY and CH UP (8) at
the same time. KEEP HOLDING THEconverter.
BUTTONS DOWN.
Note:
(4) Watch the Channel Number indicator on the
Some satellite receivers can be operated by
converter.
the REMOTE CONTROL. If you have a
Channel numbers will scan up when the
converter has been identified.Satellite Receiver, you can use the above
Release the DISPLAY and CH UP (8) as soonmethod to search for available channels.
as the channel numbers start to scan up.
The converterOs remote control code number
has been identified, and the remote is ready
to operate the converter.
47
43-47 27R-S200.p65e472/4/01, 3:51 PM |