CAUTION
? Do not allow the signal receiver window to receive strong direct sunlight, since it can
adversely affect its operation. If the signal receiver window is exposed to direct sunlight,
close a curtain to block the light.
? Using a fluorescent lamp with a quick starter in the same room may interfere with
transmission of the signal.
? The unit can be affected by signals transmitted from the remote control of a television,
VCR or other equipment used in the same room.
? Do not leave the remote control in direct sunlight or near a heater. Also, protect the unit
and remote control from moisture and shock which can discolour or damage them.
SET CURRENT CLOCK TIME
There are two clock modes:Example: 5 o'clock in the afternoon
12-hour mode and 24-hour
ClockDisplay
mode.
12-hour modePM 5:00
24-hour mode17:00
MODE1hTo set to the 12-hour mode, press the
1
CLOCK button once in the first step.
CLEAN
To set to the 24-hour mode, press the
FANCLOCK button twice in the first step.
2
SWINGPress the TIME ADVANCE or REVERSE
2
button to set the current time.
SET/C
3? Keep the button pressed to advance or
reverse the time display quickly.
1
Press the SET/C button.
3
? The colon (:) blinks to indicate that the
clock is functioning.
NOTE:
? The current time cannot be set when the
timer is operating.
E-7
AY-XP26FR-N_Eng.p65905.9.1, 2:04 PM |
ACEC
