�05:;(33&(9üú�ý&üúů÷�)662ççýç�?´çç ĺ
D�yP5�y?��ü
INSTALLING THE PRINTER DRIVER
INSTALLATION IN WINDOWS 95/98/Me/NT 4.0/2000
(PARALLEL CABLE)
The USB or parallel cable must not be When the interface selection screen
17
connected to the machine. Make sure appears, select "Parallel" and click
that the cable is not connected before the "Next" button.
proceeding.
If the cable is connected, a Plug and Play window
will appear. If this happens, click the "Cancel" button
to close the window and disconnect the cable.
NoteThe cable will be connected in step 12.
Insert the CD-ROM into your CD-ROM
2
drive.
Double-click "My Computer" ( ), and Select the printer port and click the
38
then double-click the CD-ROM icon ( )."Next" button.
Select "LPT1" for the printer port.
Double-click the "setup" icon ( ).
4
If the language selection screen appears after
Noteyou double click the "setup" icon, select the
language you wish to use and click the "Next"
button. (Normally the correct language is
selected automatically.)
Read the message in the "Welcome"
5
window and then click the "Next"
If "LPT1" does not appear, another printer or
button.Note
peripheral device is using LPT1. In this case
If you are using Windows 95/NT 4.0, go to step 8.continue the installation, and after the
installation is finished, change the port setting
so that the machine can use LPT1. This
When you are asked how the printer is
6
procedure is explained in "Another printer is
connected, select "Connected to this
using the parallel port (when using a parallel
computer" and click the "Next" cable)" on page 12.
button.
When the model selection window
9
appears, select model name of your
machine and click the "Next" button.
For the name of the model that you are using,
see "DIFFERENCES BETWEEN MODELS" in
the Operation Manual.
Click the "Yes" button.
10
6 |
ACEC
