ApollonII_keyope_ex.fm 12 Mo+ 9Ţ9�9�9a9a?9aa?�?a?
? e9�9�(9Ţ9Ţ 1
GENERAL PROGRAMS
Saddle stitch position adjustStream feeding mode
This program is used to adjust the stapling positionThis program is used to enable the stream feeding
(folding position) when using the saddle stitch functionmode of the document feeder. When the stream
of the optional saddle stitch finisher.feeding mode is enabled, additional originals which are
The value can be adjusted in 0.1 mm increments withinset in the document feeder tray within 5 seconds after
?3.0 mm from the reference position for each paperthe previous original was fed will be fed and copied
size.automatically.
NOTE
Max. +3 mmMin. -3 mm
The stream feeding mode will not function when the
Position adjusted Position adjusted
to the plus to the minus covers mode has been selected.
directiondirection
Auto paper selection setting
112Use this program to select the paper type* for which the
211
automatic paper selection function operates.
Reference positionSelections are "Plain paper", "Plain paper and recycle
[AUTOMATIC SADDLE STITCH] checkmarkpaper", and "Recycle paper".
* The paper type set for each paper tray in the paper
The saddle stitch print function can normally be divided
into the following three general steps.tray settings of the user settings (page 2-11 of the
"Operation manual (for general information and
1. The pages of the original are automatically
reordered to allow saddle stitch binding (saddlecopier operation)").
stitch function).
2. The pages are folded at the centre.Registration adjustment
Use this program when the colour of characters and
3. The paper is stapled at the centre in two places
(saddle stitch stapling).lines in colour printing is off. Registration adjustment
can be performed in two ways: manually and
The [AUTOMATIC SADDLE STITCH] checkbox is
selected by default.automatically. Normally [AUTO ADJUSTMENT]
should be used.
Selection of the checkbox assumes the use of the
above saddle stitch printing function (three steps). [AUTO ADJUSTMENT]
Touch this key to have registration adjustment
Saddle stitch stapling exceptionsperformed automatically.
Depending on the purpose of saddle stitch stapling, itAfter touching this key, touch the [EXECUTE] key. A
may be necessary to perform saddle stitch stapling onmessage appears when automatic registration
printed matter that has already been bound by saddleadjustment is completed. Touch the [EXIT] key to
stitching. In this case, it is necessary to disable step 1exit.
above. If you frequently perform this type of [MANUAL ADJUSTMENT]
exceptional saddle stitch stapling that requires
Touch this key to perform registration adjustment
disabling step 1, remove the checkmark from themanually.
[AUTOMATIC SADDLE STITCH] checkbox.
Use this key when you require a higher level of
precision than can be obtained with [AUTO
ADJUSTMENT]. See page 13 for the procedure for
manual registration adjustment.
12 |
ACEC
