MISFEED REMOVAL
Misfeed in the duplex bypass/inverter unit and duplex
module/2 x 500 sheet paper drawer
NOTE
Paper misfed from a paper tray may be extending out of the tray into the right side cover area. If the tray is drawn
out of the machine in this case, the paper may tear and become difficult to remove. To prevent this from happening,
always open the right side cover first and remove the misfed paper if it is extending into that area.
Perform steps 1 and 2 of "Misfeed in theRemove the misfed paper.
16
stand/1 x 500 sheet paper drawer" on the
2
previous page.While holding the exit
tray up, remove the
Open the upper cover of the duplexmisfed paper as shown
2
bypass/inverter unit.in the illustration. Be
careful not to tear the
misfed paper during
removal.
Close the cover of the duplex
7bypass/inverter unit and return the exit
tray to its original position.
Remove the misfeed from the upper part of
3
the duplex bypass/inverter unit.
Hold the upper cover of
the unit open while
removing the misfed
paper.
Remove the misfed paper from the bottom
8
of the duplex bypass/inverter unit.
Gently remove the
Close the upper cover of the duplexmisfed paper from the
4bypass/inverter unit.bottom of the duplex
bypass/inverter unit as
shown in the illustration,
taking care not to tear
the paper.
Make sure that there is
no misfed paper in the
machine.
Lift the exit tray if installed and open the
5
cover of the duplex bypass/inverter unit.
Pull out the duplex module of the duplex
9
module/2 x 500 sheet paper drawer.
2-27 |
ACEC
