Pegasus-E_Copy_Ex.book 85 Mo+ 9Ţ9�9�9a9a?9Ţ9�a?�?a?
? e9�9�(9a9� 1
KEY OPERATOR'S GUIDE
To enable the setting, select "DISABLE PAPER Select "AUTO POWER SHUT-OFF TIMER" and press
SIZE SET" and press the [OK] key so that a the [OK] key. The following screen will appear.
checkmark appears in the checkbox.
AUTO POWER OFF
To disable the setting, select "DISABLE PAPER
SIZE SET" once again and press the [OK] key so
5 min.
that the checkmark is cleared from the checkbox.
(5~240)
Select the desired time with the [ ] or [ ]
1
ENERGY SAVE
key.
These programs are used to configure energy saving
Press the [OK] key.
settings. To access one of these programs, select 2
"ENERGY SAVE" in the mode selection screen, and
select the desired program in the energy save screen,
and then press the [OK] key.PREHEAT MODE
This program is used to set the duration of time until
AUTO POWER SHUT-OFF
preheat mode, which automatically lowers the fusing
This program is used to enable auto power shut-off unit temperature, activates when the operation panel is
mode, which automatically turns off the power to the not used. Using this function helps conserve energy,
fusing unit if the operation panel is not used for a preserve natural resources, and reduce environmental
certain duration of time.pollution. "1 min.", "5 min.", "30 min.", "60 min.", "120
Enabling auto power shut-off mode helps conserve min.", or "240 min." can be selected for the duration of
energy, preserve natural resources, and reduce time. Select a setting that suits your work conditions.
environmental pollution.The factory default setting is "1 min.".
The function is initially enabled.
Select "PREHEAT MODE" and press the [OK] key.
Rather than disabling the auto power
The following screen will appear.
Noteshut-off feature, it is recommended that you
first try lengthening the time set in "AUTO PREHEAT MODE
POWER SHUT-OFF TIMER" (see below).
In most cases a suitable timer setting will
1 min.
allow work to proceed with minimal delay
and still enable you to enjoy the benefits of (1~240)
power conservation.
To enable auto power shut-off mode, select "AUTO
POWER SHUT-OFF", and press the [OK] key so Select the desired time with the [ ] or [ ]
1
that a checkmark appears in the checkbox.key.
To disable auto power shut-off mode, select
Press the [OK] key.
27"AUTO POWER SHUT-OFF" once again and press
the [OK] key so that the checkmark is cleared from
the checkbox.
TONER SAVE MODE
The toner save mode will reduce toner consumption by
AUTO POWER SHUT-OFF TIMERapproximately 10% in the automatic and text,
exposure modes. Copies will be lighter but still
This program is used to set the duration of time until
adequate for general use. Selection of this mode has
auto power shut-off mode activates when the
no effect on the photo mode.
operation panel is not used. Using this function helps
The function is initially disabled (factory default
conserve energy, preserve natural resources, and
setting).
reduce environmental pollution.
"5 min.", "30 min.", "60 min.", "120 min." or "240 min."
To turn on the toner save mode, highlight "TONER
can be selected for the duration of time. Select a
SAVE MODE" and press the [OK] key to display a
setting that suits your work conditions.
check mark in the check box.
The factory default setting is "5 min.".
To turn off the toner save mode, select this
program and press the [OK] key again to clear the
check mark in the check box.
85 |
ACEC
