AR_S11_03-06.fm 5 Mo+ 9Ţ9�9�9�9�?9�9�a???a?
? e9a(9á9a 1
USING THE 20-BIN SORTER
Place the original in the document feederTouch the key for the desired output
15
tray (when a reversing automaticmode.
document feeder is installed) or on theREADY TO COPY.The touched key is
document glass. (Refer to page 4-6 ofhighlighted to indicateOUTPUT
"Operation manual (for generalNON SORTthat the function isSORTER
enabled.
information and copier operation)".)
SORT
If the original was placed
GROUPon the document glass in
step 1, non-sort mode is
automatically selected. If
the original was placed in the document feeder tray,
sort mode is automatically selected.
Touch the [OK] key.
6
Select copy settings as needed, including
2INTERRUPT
two-sided or one-sided copy mode, paper0
size select, exposure adjustment, and
OK
copy ratio. (Refer to chapter 5 of
CENTRE TRAY
"Operation manual (for general
information and copier operation)".)
Touch the [OUTPUT] key.
3
Set the number of copies as needed and
7
press the [COLOUR COPY START ()]
or [BLACK COPY START ()] key.
2-SIDED COPY
Replace the original with
the next original and
OUTPUTpress the [START] key.
Repeat this operation
until all originals have
been scanned.
Touch the [SORTER] key.
4
READY TO COPY.
OUTPUT
SORTER
SORT
GROUP
NOTES
Maximum number of original pages
This is the maximum number of original pages that can be copied at once in sort mode or group mode.
In sort mode: The limit is the same as the maximum number of sheets that can be held in one bin. (See *1 in
the "SORTER CAPACITY" table on page 3.)
In group mode: Up to 20 sheets (the same as the number of bins in the sorter).
Maximum number of copies that can be set
The maximum number of copies that can be set in sort mode and group mode is as follows:
In sort mode: Up to 20 copies (the same as the number of bins in the sorter)
In group mode: The number of sheets that can be held in one bin (See *2 in the "SORTER CAPACITY" table on page 3.)
When "Transparency film with insert sheets" or "A3 (11" x 17") Full-bleed" is selected (these are special
functions), the copies are output in non-sort mode. Sort and group modes cannot be selected.
To cancel a copy run, press the [CLEAR] key. Copying will stop and the number in the copy quantity display will
be reset to 0.
5 |
ACEC
