Preparation for Video CD Playback
! Adjusting the TV and VCR! Selecting the video output format
The TV and VCR input varies according to connection method. Be sure to make theVideo CD is recorded in PAL or NTSC format.
settings correctly. (Then, follow the playback procedure on pages 17 - 18 to check theSelect the video output format (NTSC or PAL) according to your TV or VCR.
settings.)
To select the video output format:
Whilst in the stop mode, press the PAL/NTSC button.
<For TV sets with a video input socket>Each time this button is pressed, the format will change in the following order:
TV
NTSC PAL
Notes:
" Video CDs are recorded in PAL or NTSC format. When you watch a PAL disc in
the NTSC mode or an NTSC disc in the PAL mode, the vertical size of the picture
will not be modified.
" If a multi-mode TV is equipped with an input selector switch, set the switch to
"MULTI MODE". For the details, refer to the TV operation manual.
Set the input selector " Do not change the video output format during playback. If you do, the picture sig-
to VCR.nal may not be output properly.
" Picture may be distorted when the setting is switched. This is not the malfunction
of the unit.
<For TV sets without a video input socket>
" A few hours after the unit is unplugged, the setting will change back to the state at
the factory shipment (default setting). The setting details vary depending on areas.
Set the input selector
to AUX.
Set the TV/VCR selector
to VCR.
TVVideo CD Playback
- Preparation for Video CD Playback -
VCR
Set the input selector
to VCR.
ENGLISHE-16
01/10/12CD-BK260V(X)E2.fm |
ACEC
