CD-M4000W
General Control
? Demonstration mode
? Setting the FM/AM span selector
The first time the unit is plugged, the unit will enter
the demonstration mode. You will see words scroll.
To cancel the demonstration mode:
When the unit is in the power stand-by mode (demonstration mode), press the MON-
STER-BASS button. The demonstration mode will be cancelled and the display will
disappear.
To return to the demonstration mode:
When the unit is in the power stand-by mode, press the MONSTER-BASS button
again.
Note:
When the power is on, the MONSTER-BASS button can be used to select the extra
bass mode.
? To turn the power on
Press the ON/STAND-BY button to turn the power on.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
The International Telecommunication Union (ITU) has established that? mTeomber cou changn-e the display brightness (2 levels)
tries should maintain either a 100 kHz or a 50 kHz interval between broadcasting fre-
You can switch the display brightness by pressing the DIMMER button.
quencies of FM stations and 10 kHz or 9 kHz for AM station. The illustration shows
the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2).
Before using the unit, set the SPAN SELECTOR switch (on the rear panel) to the
interval (span) of your area.Preparation for Use
- System Connections / General Control -
To change the tuning zone:DimmedBrightened
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Set the SPAN SELECTOR switch (on the rear panel) as follows.
z For 50 kHz FM interval (9 kHz in AM) 50/9
z For 100 kHz FM interval (10 kHz in AM) 100/10
3 Whilst pressing down the button and the MONSTER-BASS button, press the ON/
STAND-BY button until "CLEAR AL" appears.
Caution:
This operation will erase all data stored in memory including clock, timer settings,
tuner preset, and CD programme.
ENGLISHE-10
01/5/18CD-M4000W(X)E1.fm |
ACEC
